Author Topic: Encore Weaver scope base (Read 470 times)

reddeer · « **on:** September 24, 2005, 05:16:37 PM »

What's the best way of supporting the Weaver base end that hangs over the barrel taper, it seems a bit too flexible for my liking. Should I fill the gap with epoxy or drill and tap and use a small bolt/screw to support it? I want to mount the scope as far forward as possible using extended rings.

iiibbb · « **Reply #1 on:** September 24, 2005, 05:27:00 PM »

The Warne-weaver mount is very rigid... no problem with it.

reddeer · « **Reply #2 on:** September 24, 2005, 10:52:19 PM »

iiibbb Thanks very much for the advice, I knew there had to something stronger.

Redhawk1 · « **Reply #3 on:** September 25, 2005, 01:35:43 AM »

I think the Warne mount is the best out there. JMHO.

http://www.warnescopemounts.com/