Author Topic: Buffalo Bullets  (Read 747 times)

0 Members and 2 Guests are viewing this topic.

Offline Swamp Yankee

  • Trade Count: (0)
  • Avid Poster
  • **
  • Posts: 207
Buffalo Bullets
« on: October 20, 2005, 12:06:55 PM »
I just bought 14 boxes of 50 cal 385 grain Buffalo Bullets from E-Bay for $29.00, I just couldn't pass them up. I called the factory to find out what they consider to be a good charge to put behind one but......they are all on vacation this week for hunting season [I'd sure like to work there!]  So I thought that I might ask the members of the fourm if they have had any experience with them and find out what kind of loads they used. I will be shooting them out of my TC Hawken as it is the only rifle with a 1 in 48 twist [all the rest are 1 in 66] I have FF Swiss and FF and FFF Goex  on hand. Any advice would be appreciated.  Thanks,  Jim

Offline clodbuster

  • Trade Count: (3)
  • A Real Regular
  • ****
  • Posts: 551
  • Gender: Male
buff bullets
« Reply #1 on: October 20, 2005, 04:14:32 PM »
My renegade 50 loves the 385's but deer hate 'em.  I use pyrodex rs at 90 grains and FF swiss at 80.  2-3 inch groups at 75 yds.  what a kick from this load however.
Preserve the Loess Hills!!!

Offline BS

  • Trade Count: (0)
  • Avid Poster
  • **
  • Posts: 147
    • http://webpages.charter.net/fam-strick/web/index.htm
Buffalo Bullets
« Reply #2 on: October 21, 2005, 12:10:35 PM »
80-90 grains of 2F should work just fine, but you can also try 3F and don't for get to put a 'wad' under the bullet. It helps most of the time.

some of the info that I have gathered:

I shoot Hornady 410s with a MMP SUB-BASE, I also shoot a 370 Grain Maxi with
a card wad under the bullet!

My groups wint from 3-4" at 100yds down to 1 1/2 and smaller just by using
the sub-base and the card wad under the bullets. My loads are Goex, 90FFF to
115FF, out of my .50 cal. with a 1 in 30 twist.


Some of the WAD links that I have found

http://www.buffaloarms.com/browse.cfm/browse.cfm/4,4964.html
http://www.sagebrushproducts.com/ShootingProducts.htm
http://www.circlefly.com/
http://www.trackofthewolf.com/categories/tableList.aspx?catID=2&subID=37&styleID=118

Some of the more expensive " Veggie" wads are made from:

Vegetable fiber gasket material engineered to resist high heat & compression
and water resistant.

Or you can make your own with some heavy card stock and a Gasget [Arch]
punch.
Get Close, and Whack'em Hard!

Offline R J Kellems

  • Trade Count: (0)
  • Member
  • *
  • Posts: 6
Buffalo Bullets
« Reply #3 on: October 22, 2005, 04:04:46 PM »
I have had good success with the .50 cal. buffalo ball in my TC Hawken using 80 grains of 2f black power
RJ

Offline Swamp Yankee

  • Trade Count: (0)
  • Avid Poster
  • **
  • Posts: 207
Buffalo Bullets
« Reply #4 on: October 22, 2005, 04:28:16 PM »
Guys,
Thanks for the info. I can't wait to get to the range and try them out, if it would only stop rainning. I planned on using the Ox-Yoke over powder wads, I even use them under a patched round ball. I like to keep a good supply on hand [500 or 600] but I had heard that Ox-Yoke has gone into recivership so I've started to lay in a extra supply of 50's and 54's not knowing what the outcome of the company will be.
Thanks again, Jim

Offline slayer

  • Trade Count: (3)
  • A Real Regular
  • ****
  • Posts: 937
Buffalo Bullets
« Reply #5 on: October 22, 2005, 04:38:29 PM »
My muzzleloaders love the BB Ball-Et`s. 245 gr. .50 cal version. i shot a deer in the neck on the side, and broke the neck and cut the juggular, but it didn`t go right thru, it either ran down the neck or pancaked, not sure? Jack.

Offline farrerhaven

  • Trade Count: (0)
  • Member
  • *
  • Posts: 40
Buffalo Bullets
« Reply #6 on: November 03, 2005, 05:28:20 PM »
I had a T/C hawkins that loved those 385 gains slugs.1OO grains of 2ff Geox used to give me 3 inch groups at 100yards.Brian.
NRA life member.