« previous next »
Pages: [1]   Go Down

Author Topic: Ruger Blackhawk Timing Question  (Read 684 times)

0 Members and 1 Guest are viewing this topic.

Offline Woodtroll

  • Trade Count: (0)
  • Member
  • *
  • Posts: 49
Ruger Blackhawk Timing Question
« on: November 27, 2005, 03:09:04 AM »
Hello, folks! I have a Ruger Blackhawk that drops the bolt well before the cylinder lead notch. I have tried lengthening the plunger pin in the hammer, which made the timing PERFECT for a while, but then the bolt started dropping the same place again, as if one of the springs were losing strength. Isn't the timing somewhat a function of spring balance, as well, rather than an exact mechanical relationship? Should I try slightly strengthening the plunger spring, or lightening the bolt spring a tiny bit? Any suggestions would be appreciated. Thanks! Regan
Logged

Offline BlkHawk73

  • GBO Supporter
  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 1501
  • Gender: Male
Ruger Blackhawk Timing Question
« Reply #1 on: November 27, 2005, 03:33:48 AM »
Not wanting to give the wrong info, I'd suggest you ask this over at Ruger Forum.  There's a few there that can diagnose these things pretty well and proberly give direction on how to solve the problem.
Logged
"Never Surrender, Just Carry On."  - G.S.

Offline Woodtroll

  • Trade Count: (0)
  • Member
  • *
  • Posts: 49
Thanks!
« Reply #2 on: November 27, 2005, 05:31:31 AM »
Thanks for the suggestion- I didn't know that that board existed. I appreciate your help!
Logged

Offline Jerry Lester

  • Trade Count: (0)
  • A Real Regular
  • ****
  • Posts: 928
Ruger Blackhawk Timing Question
« Reply #3 on: November 27, 2005, 01:46:13 PM »
Logged
Pages: [1]   Go Up
« previous next »