« previous next »
Pages: [1]   Go Down

Author Topic: Pistol grip cap repair  (Read 477 times)

0 Members and 1 Guest are viewing this topic.

Offline jpsmith1

  • Trade Count: (0)
  • Contributor
  • ***
  • Posts: 342
Pistol grip cap repair
« on: November 27, 2005, 01:39:05 PM »
I have a Remington m700 and the plastic pistol crip cap fell off of the stock.  It's a wood stock with what appears to be a thin plastic washer between the cap and wood.  What's the best way to replace this piece on the gun.  What type of glue should I use?
Logged
Searching for the perfect left handed revolver.....

Offline John Traveler1

  • Trade Count: (0)
  • Contributor
  • ***
  • Posts: 265
grip cap repair
« Reply #1 on: November 27, 2005, 05:54:06 PM »
Brownells Accraglas would be best for this repair.  Lacking that, any fast-setting colorless (clear) epoxy cement will work well.  Your should sand the surfaces using 200 grit wet or dry paper first to improve adhesion.
Logged

Offline gunnut69

  • Moderators
  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 5005
Pistol grip cap repair
« Reply #2 on: November 27, 2005, 09:03:53 PM »
I thought these were screwed to the stock..but the repair is quite similar.. AcraGlass is great for this kind of repair but I regularly use DevCon 5-ton epoxy for this sort of thing and have had great luck..
Logged
gunnut69--
The 2nd amendment to the constitution of the United States of America-
"A well regulated militia, being necessary to the security of a free state, the right of the people to keep and bear arms, shall not be infringed."

Offline jpsmith1

  • Trade Count: (0)
  • Contributor
  • ***
  • Posts: 342
Pistol grip cap repair
« Reply #3 on: November 28, 2005, 06:55:23 AM »
Thanks guys.  I was thinking about using super-glue but just the thought of supergluing my gun back together just bothered me.
Logged
Searching for the perfect left handed revolver.....
Pages: [1]   Go Up
« previous next »