« previous next »
Pages: [1]   Go Down

Author Topic: 9.3x74R ?  (Read 424 times)

0 Members and 1 Guest are viewing this topic.

Offline Uncle Ji

  • Trade Count: (0)
  • Avid Poster
  • **
  • Posts: 170
  • Gender: Male
  • ILLEGITIMUS NON CARBORUNDUM EST
    • Hawaiian Style
9.3x74R ?
« on: April 01, 2006, 01:42:14 PM »
I love all the German 9.3 cartridges but especially the 9.3x74R.  Has anyone here had their Handi barrel bored out and chambered for this cartridge?  What barrel did you start with, who did the work, and how much did it cost?  THANKS!
Logged

Offline quickdtoo

  • Global Moderator
  • Trade Count: (149)
  • Senior Member
  • *****
  • Posts: 43301
  • Gender: Male
9.3x74R ?
« Reply #1 on: April 01, 2006, 03:57:37 PM »
Don't think so, not yet anyway!! But I've done a .338-06 A-square from a .25-06 and .405 Winchester from a .38-55 Target, Wayne York of Oregunsmithing did the work, he charges about $300 for a rebore/rechamber. He's done work for several members here. He just did a .35 Remington rechamber from .357Mag for me, too.

Tim

http://home.earthlink.net/%7Eoregunsmithing/index.html
Logged
"Always do right, this will gratify some and astonish the rest" -  Mark Twain

Offline RemingtonMagnum

  • Trade Count: (5)
  • Contributor
  • ***
  • Posts: 487
Bore
« Reply #2 on: April 01, 2006, 04:06:43 PM »
A 9.3x74R has a .366 bore. I used these shells in creating a brass case for a 410 to a Brass shell and bullet like a slug.

Don Jackson Remington Magnum/Ultramag
Logged

Offline Uncle Ji

  • Trade Count: (0)
  • Avid Poster
  • **
  • Posts: 170
  • Gender: Male
  • ILLEGITIMUS NON CARBORUNDUM EST
    • Hawaiian Style
9.3x74R ?
« Reply #3 on: April 01, 2006, 07:50:15 PM »
Thank you very much Tim, I'll give Wayne an email to see if this is doable.
Logged
Pages: [1]   Go Up
« previous next »