Author Topic: Does NEF sell extra barrels for the Pardner Pump? (Read 1412 times)

myarmor · « **on:** February 19, 2006, 06:05:27 AM »

Like the Slug, Turkey, and Youth barrels?..I'm guessing they do, but am not sure.
I have never seen them offered in the catalog or barrel program.
-Aaron

Cookiemann · « **Reply #1 on:** February 19, 2006, 08:42:38 AM »

Give'em a call...I just can't remember what they are. I called them for my nephew a while back. Yes, they do, I only called about a slug barrel, though.
cookie

myarmor · « **Reply #2 on:** February 19, 2006, 09:06:59 AM »

I'll call tomorrow and post what they say.

RackWrangler · « **Reply #3 on:** February 19, 2006, 12:55:19 PM »

I sent them an email asking about getting the slug barrel for my gun, and they said that it would cost $124.00 for the barrel plus $7.50 for shipping.

I really like the shotgun, but when you only pay $140 for the entire gun, why pay $120 more for a barrel?

I am still fighting the urge to go against logic and do it. :roll:

In most zones in southern WI, shotgun (or pistol) is all that is allowed for deer.

The pump would be nice, but I seldom hunt down here, and when I do it is while doing a drive for someone else, so I just carry my 357 mag pistol since it's lighter and just as fast.

I'm still undecided...hope this helps.

RackWrangler

myarmor · « **Reply #4 on:** February 19, 2006, 01:35:31 PM »

Humm.. I was curious about that. Your right, with $140-150 for the Shotgun itself, is hard to justify paying out $131 for another barrel...that you just did pay only $10-20 for the ENTIRE gun! :? :x :roll:
Weird.

Well ok another question, what are the scope mounting options for these guys?

I am low on speed when it comes to these Shotguns :oops:

Markus · « **Reply #5 on:** February 19, 2006, 02:04:01 PM »

If you had an 870 you could pick up a used barrel on ebay for less than $100.00. I'd just buy a tracker2 if you feel the need for a rifled barrel.

Critter · « **Reply #6 on:** February 19, 2006, 07:10:24 PM »

How close is the reciever to an 870? If the trigger housing pin diameter, distance between pins and reciever width is the same you could use any of the saddle mounts for the 870/1100/1187 line. Otherwise it would be a pretty simple drill and tap job.