Author Topic: do cowboy loads cause more residue buildup?  (Read 1187 times)

0 Members and 3 Guests are viewing this topic.

Offline gunpilot

  • Trade Count: (0)
  • Avid Poster
  • **
  • Posts: 165
  • Gender: Male
do cowboy loads cause more residue buildup?
« on: October 03, 2006, 07:25:04 PM »
I shot ultramax factory cowboy ammo in my vaquero and noticed a lot of black residue. Do these cause more residue buildup than standard factory loads?

Offline LEO

  • Trade Count: (0)
  • Contributor
  • ***
  • Posts: 421
Re: do cowboy loads cause more residue buildup?
« Reply #1 on: October 04, 2006, 06:06:12 AM »
I have not shot any of Ultramax's cowboy loads but have shot some of their other loads and their ammo just seems to be dirtier than some other brands.  Function was good, accuracy was ok just more fouling than normal.

Offline leverfan

  • Trade Count: (8)
  • A Real Regular
  • ****
  • Posts: 823
Re: do cowboy loads cause more residue buildup?
« Reply #2 on: October 04, 2006, 06:46:13 PM »
I haven't shot any factory ammo at a match, except for some shotgun loads from time to time.  Ultramax is probably using a dirty burning powder.  If you reload, there are plenty of clean burning options that will, if loaded to adequate pressure, leave your gun with minimal fouling.

Usually, I shoot Frontier Cartridge class, and load up with Goex ffg, and I sure hope your Ultramax ammo is shooting cleaner than that! ;D
NRA life member

Offline LEO

  • Trade Count: (0)
  • Contributor
  • ***
  • Posts: 421
Re: do cowboy loads cause more residue buildup?
« Reply #3 on: October 07, 2006, 05:52:38 AM »
leverfan, I don't know about gunpilots loads but the ones I shot were not a whole lot cleaner than black.  My stainless revolver looked black when I finished a box.  But like I said shot fine just dirty

Offline Bitterroot Bob

  • Trade Count: (0)
  • Avid Poster
  • **
  • Posts: 249
Re: do cowboy loads cause more residue buildup?
« Reply #4 on: March 03, 2007, 03:15:21 AM »
Howdy,
The amount of residue left behind varies from powder to powder. My Unique powder .44-40 loads smoke more that most .38 Spl BP loads (which doesn't say much for the gamers who shoot them in BP class), but much of that is simply the graphite coating that controls the burn rate of modern powders. It leaves a gray film that wipes off.
What I have noticed is that most reduced .45 Colt loads do not develop enough pressure to swell the brass case and seal the chamber when fired. That results in gas being blown back between the chamber and the case, leaving a red-hot empty and a lot of black soot on the brass. The only cure is to use a heavier bullet, a bulkier powder that better fills the case, like Trailboss, or a faster powder that builds pressure quickly, like Bullseye, AA#2, or Tightgroup.


Bitterroot

Offline shaner

  • GBO Supporter
  • Trade Count: (66)
  • Senior Member
  • *****
  • Posts: 2057
  • Gender: Male
Re: do cowboy loads cause more residue buildup?
« Reply #5 on: March 03, 2007, 03:28:34 AM »
i also think alot of the  residue is the lead  bullet, lcast lead will burn also and leave  things black, i can use the same load usin berrys  bullets ,and have half the  dirt