Author Topic: Which Boresighter?  (Read 486 times)

0 Members and 1 Guest are viewing this topic.

Offline Mark1

  • Trade Count: (1)
  • Member
  • *
  • Posts: 14
Which Boresighter?
« on: July 22, 2006, 01:57:57 PM »
I've always either borrowed one or just started close to the target. It's finally time to get one. It also has to work in stainless barrels. Are the lasers worth the extra money?

Offline lovedogs

  • Trade Count: (0)
  • Avid Poster
  • **
  • Posts: 119
Re: Which Boresighter?
« Reply #1 on: July 24, 2006, 11:33:00 AM »
Personally, I don't think any of them work that great.  I'm real fussy about sticking things in my barrels and since none work really that good I've started using the Leupold magnetic ones.  They work okay.  As good as any, I guess.  In reality, I can get closer by sighting down the bores and aligning the scope.  But that wouldn't work on some actions, of course.

One of the best uses I've found for the bore sighters is to check a scope out.  You can easily tell if it's adjusting as it should by watching through a bore sighter as you crank the knobs.

By the way, the magnetic ones work on stainless barrels, too.

Mike

Offline rickyp

  • Trade Count: (19)
  • Senior Member
  • *****
  • Posts: 3052
  • Gender: Male
Re: Which Bore sighter?
« Reply #2 on: July 24, 2006, 12:20:06 PM »
OK, I have a Bushnell bore sighter. The arbors are chrome plated with a copper wire to hold it tight in the bore. I have yet to see any one scratch a bore.
I can normally get it very close to being perfect at 40 yards. my biggest mistakes put me way right of the paper but that is my flat.
Here is what I have found using mine:
the Bushnell works great with high power scopes but not so well with low power handgun scopes and for iron sights forget about using it. I am trying to save up the money for a laser bore sighter they all have a rubber ring to keep it centered  and from toughing the bore. the laser will be much better for low power scopes and even open sights. the down side you have to put a target on the wall.

Offline Redhawk1

  • Life time NRA Supporter.
  • GBO Supporter
  • Trade Count: (78)
  • Senior Member
  • *****
  • Posts: 10748
  • Gender: Male
Re: Which Boresighter?
« Reply #3 on: July 24, 2006, 02:57:33 PM »
I've always either borrowed one or just started close to the target. It's finally time to get one. It also has to work in stainless barrels. Are the lasers worth the extra money?

I use a Leupold magnetic one. It always gets me on paper which is what it was intended for.

People think a bore sight replaces going to the range and doing a proper sight it.  I don't care how good a bore sight is, you need to shot your gun to make adjustments and make sure it is on.
If  you're going to make a hole, make it a big one.
ΜΟΛΩΝ ΛΑΒΕ
Only two defining forces have ever offered to die for you,
Jesus Christ and the American G. I.
One died for your soul, the other for your freedom

Endowment Life Member of the NRA
Life Member NA