« previous next »
Pages: [1]   Go Down

Author Topic: Need help with a problem  (Read 396 times)

0 Members and 3 Guests are viewing this topic.

Offline handgunhuntr

  • Trade Count: (33)
  • Contributor
  • ***
  • Posts: 403
Need help with a problem
« on: July 26, 2006, 03:34:14 PM »
Ok, lets give this a try.  I have a pre G2 contenderand a new custom shop 357 maximum barrel.  I went to the range tonight and heres what happened.  First 2 rounds had a light primer strike, 3 and 4 blew the action open.  No as far as a overloaded round, this wasnt the case.  I measure ever round when I loaded, and when I came home tonight, I took them apart and measured again.  These loads came directly from the Contender load book and were not listed max.  Whats going on?
Logged
This is the Land of the Free..Only because of the Brave!! 
US Air Force Veteran

Offline KN

  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 1962
Re: Need help with a problem
« Reply #1 on: July 26, 2006, 03:58:31 PM »
Sounds like a problem with barrel lugs to me.   KN
Logged

Offline skb2706

  • Trade Count: (5)
  • Senior Member
  • *****
  • Posts: 1428
Re: Need help with a problem
« Reply #2 on: July 27, 2006, 10:15:50 AM »
Sounds like excessive breech face to barrel gap...which also means poor lock up with the frame. I would send the gun to TC and have them make it right.
Logged
Pages: [1]   Go Up
« previous next »