« previous next »
Pages: [1]   Go Down

Author Topic: swabbing between shots ?  (Read 1002 times)

0 Members and 1 Guest are viewing this topic.

Offline shilo

  • Trade Count: (0)
  • Avid Poster
  • **
  • Posts: 244
swabbing between shots ?
« on: August 25, 2006, 04:32:46 PM »
Do you swab between shots? If so, what do you use?
Logged

Offline quickdtoo

  • Global Moderator
  • Trade Count: (149)
  • Senior Member
  • *****
  • Posts: 43301
  • Gender: Male
Re: swabbing between shots ?
« Reply #1 on: August 25, 2006, 04:35:00 PM »
If I need to, a spit patch and a dry patch.

Tim
Logged
"Always do right, this will gratify some and astonish the rest" -  Mark Twain

Offline Biff Mayhem

  • Trade Count: (0)
  • Avid Poster
  • **
  • Posts: 223
  • Gender: Male
Re: swabbing between shots ?
« Reply #2 on: August 25, 2006, 04:43:42 PM »
Winter Formula (de-icer) windshield washer solution from Wal*Mart. Put it in a small spray bottle they sell over in the Cosmetics section of the store. Magnum powder loads in my sabot inline need every shot-swabbing. My roundball and lubed conical guns that use less powder require a swab every 2-3 shots. :)
Logged
Keep that ML smokin'
Dave

Offline davestewart38

  • Trade Count: (0)
  • Member
  • *
  • Posts: 9
Re: swabbing between shots ?
« Reply #3 on: August 25, 2006, 07:49:17 PM »
I use anhydrous isopropyl alcohol to swab between shots.I use both sides of the patch.This stuff dries in the bore very quickly after swabbing.I have found that swabbing greatly improves the accuracy of my muzzleloaders.If I am shooting roundballs I then load normally.If I am using sabots,I follow the alcohol patch with a bore butter patch and use both sides to swab the bore.This makes the sabots easier to load and I get better accuracy than by using the sabots in a dry bore.
Logged

Offline Redhawk1

  • Life time NRA Supporter.
  • GBO Supporter
  • Trade Count: (78)
  • Senior Member
  • *****
  • Posts: 10748
  • Gender: Male
Re: swabbing between shots ?
« Reply #4 on: August 26, 2006, 02:02:10 AM »
If I do and it is very seldom I swab between shots, I was a patch with Windex with Vinegar and then a dry patch.
Logged
If  you're going to make a hole, make it a big one.
ΜΟΛΩΝ ΛΑΒΕ
Only two defining forces have ever offered to die for you,
Jesus Christ and the American G. I.
One died for your soul, the other for your freedom

Endowment Life Member of the NRA
Life Member NA

Offline shilo

  • Trade Count: (0)
  • Avid Poster
  • **
  • Posts: 244
Re: swabbing between shots ?
« Reply #5 on: August 26, 2006, 09:44:13 AM »
Windshield washer fluid, isopropyl alcohol, and windex with vinegar ? That's quite a variety. I'll have to give those a try. I've been using TC #13 or TC # 17. Other than those being cheaper than the TC products is there an advantage to those over the TC stuff? Or is the TC stuff really not that good? Thanks.
Logged

Offline gt2003

  • Trade Count: (0)
  • Member
  • *
  • Posts: 91
Re: swabbing between shots ?
« Reply #6 on: August 26, 2006, 12:40:36 PM »
Simple.  I take the 1st patch and wet it in my mouth with saliva.  I swab my barrel with the 1st side of the patch, turn the patch over and swab my barrel with the second side.  Then, i take a dry patch and do the same.  This seems to work extremely well.  Bullets have touched each other numerous times, even without a bench type rest.  I think the main thing is to get the major fouling out of the barrel.  My gun shoots in the same place when its 100% unfired, clean as it does after the swabbing process mentioned above.  Good luck, gt2003 (Greg)
Logged

Offline cynrays

  • Trade Count: (0)
  • Member
  • *
  • Posts: 61
Re: swabbing between shots ?
« Reply #7 on: August 28, 2006, 02:09:37 PM »
I use alcohol prep pads. These are the pads that are solked in alcohol that the people use before insulin shots. After each shot I run one up and down the bore and do not have any trouble. They are 98 cents at wal mart for 100. Each one is in a package...
Logged

Offline daddywpb

  • Trade Count: (4)
  • Senior Member
  • *****
  • Posts: 1136
Re: swabbing between shots ?
« Reply #8 on: August 28, 2006, 10:30:14 PM »
Quote from: cynrays on August 28, 2006, 02:09:37 PM
I use alcohol prep pads. These are the pads that are solked in alcohol that the people use before insulin shots. After each shot I run one up and down the bore and do not have any trouble. They are 98 cents at wal mart for 100. Each one is in a package...

I use alchohol also, but I'm going to get some of those! Great idea.
Logged

Offline cynrays

  • Trade Count: (0)
  • Member
  • *
  • Posts: 61
Re: swabbing between shots ?
« Reply #9 on: August 29, 2006, 02:32:04 AM »
The prep pads work great. The alcohol is dry by the time that you are ready to pour the powder in. After about ten shots I run the brass cleaning brush up and down a couple of times. I have not had to use anything else...
Logged

Offline Biff Mayhem

  • Trade Count: (0)
  • Avid Poster
  • **
  • Posts: 223
  • Gender: Male
Re: swabbing between shots ?
« Reply #10 on: August 29, 2006, 06:18:28 AM »
What diameter are those prep-pads?

I like a minimum of 2-1/2" patches ... usually buy 3" because they carry more fouling.
Logged
Keep that ML smokin'
Dave
Pages: [1]   Go Up
« previous next »