« previous next »
Pages: [1]   Go Down

Author Topic: Cast in breaks  (Read 540 times)

0 Members and 1 Guest are viewing this topic.

Offline lostchild

  • Trade Count: (0)
  • Member
  • *
  • Posts: 70
Cast in breaks
« on: April 19, 2003, 03:13:58 PM »
I have a TC 10" bbl with a break when I shoot a heavy (300gr) at about 1800/fps I get a white coating all over my break is this normal?  The load is just below max and I'm using CDP 300gr simi speerpoints.  Accucaracy is good but I don't know about this white coating,  its both inside and outside of the break.   Thanks in advance   lost
Logged

Offline jhalcott

  • Trade Count: (1)
  • Senior Member
  • *****
  • Posts: 1869
cast in breaks
« Reply #1 on: April 21, 2003, 07:05:33 AM »
what caliber are you using? and do you use a gas check? This coating may be lube OR it may be lead scraping off as the bullet passes thru the break.It is not likely powder fouling,but!!!!
  what kind of accuracy are you getting with other bullets compared to the heavies?   jh
Logged

Offline Nobade

  • Trade Count: (2)
  • Senior Member
  • *****
  • Posts: 1927
Cast in breaks
« Reply #2 on: April 21, 2003, 08:15:47 AM »
Probably lead deposited on the brake. You get a little lead vapor coming out after the bullet, and it condenses on the brake. Use some compensator spray like the IPSC guys use or some splatter spray you use with a MIG welder and it'll make the stuff easier to remove.
Logged
"Give me a lever long enough, and a place to stand, and I'll break the lever."
Pages: [1]   Go Up
« previous next »