Author Topic: need help with lyman sizer (Read 640 times)

kevin · « **on:** April 24, 2003, 06:56:14 PM »

Well i have a used lyman luber sizer comming from auction, and need help in getting the right sizer dies and top punches, i've pan lubed and sized bullets for skirmishing, and this here sizealuber stuff gots me confused i know i need top punches and sizer dies but what do you order, for 7mm 160 grain,and 358dia,160 grain bullets?, and another question , how does the luber thinger seat gas checks on the bullet ? and were do you get infomation/instructions on how this here machine works, i hope you all can help.
kevin

Lloyd Smale · « **Reply #1 on:** April 25, 2003, 12:02:03 AM »

usually go .01-.02 over bore diameter for your sizing die. Top punch will depend on the style of bullet being used lyman and rcbs usually list top punch style needed for each bullet most guys though just make themselves a flat one and use it for everything but the round nosed bullets. Yes it will seat gas checks make sure there on square though before you run them through the sizer. they will be crimped on (if you buy good hornadys not the lyman crap) when you run the bullet through the sizer.

Omaha Poke · « **Reply #2 on:** April 26, 2003, 02:58:56 PM »

Lyman also makes a special crimp die for gas checks. Omaha

ButlerFord45 · « **Reply #3 on:** April 27, 2003, 12:07:47 AM »

http://www.lymanproducts.com/lymanproducts/Instruction%20Guide%2014.pdf I noticed this on lyman's site recently, is this what your looking for?

Johm D M · « **Reply #4 on:** April 27, 2003, 02:58:19 PM »

Slug your bore and throat with lead sinkers [oval egg] and measure with a quality Micrometer that you or your mechanic would own. Buy your sizing dies .001 larger than that measurement for best accuracy. Gianni.