« previous next »
Pages: [1]   Go Down

Author Topic: Will dry firing hurt ?  (Read 845 times)

0 Members and 1 Guest are viewing this topic.

Offline billycraig

  • Trade Count: (0)
  • Member
  • *
  • Posts: 8
Will dry firing hurt ?
« on: February 21, 2007, 05:10:10 PM »
Hi , will dry firing hurt the 336 rifles and if it is ok to do this Repeatedly do I need to leave the safety in the on position or the off position ? Thanks ,BillyCraig
Logged

Offline victorcharlie

  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 3573
Re: Will dry firing hurt ?
« Reply #1 on: February 23, 2007, 12:23:27 AM »
Most modern center fire rifles will not be hurt by dry firing.  That said, If I were going to do it a lot, I'd get a snap cap, or put an eraser in a spent cartridge to give the firing pin a place to land.  Anything, done to excess, has consequences.
Logged
"Extremism in the defense of liberty is no vice. Tolerance in the face of tyranny is no virtue."
Barry Goldwater

Offline ba_50

  • Trade Count: (0)
  • Avid Poster
  • **
  • Posts: 222
  • Gender: Male
Re: Will dry firing hurt ?
« Reply #2 on: March 10, 2007, 10:55:31 AM »
I use once fired cases with spent primers and dry fire about 3x in the rifle they were shot in, otherwise a case might get stuck in the chamber.
Logged

Offline ScoutMan

  • Trade Count: (0)
  • Contributor
  • ***
  • Posts: 287
Re: Will dry firing hurt ?
« Reply #3 on: March 10, 2007, 11:33:55 AM »
Snap caps are never a mistake.

That being said, what I do with exposed hammer rifles is put a piece of surgical tubing, gas line hose, or piece of an eraser cut to fit, between the hammer and the bolt block to reduce the trauma on them.
Logged
If you can get closer, get closer
If you can get steadier, get steadier.

A telescope helps you see; it does not help you hold and squeeze.-Jeff Cooper
Pages: [1]   Go Up
« previous next »