Author Topic: Bedding the Barrel and Barrel Lug to the Action with Picture  (Read 493 times)

0 Members and 1 Guest are viewing this topic.

Offline McLernon

  • GBO Supporter
  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 1217
Bedding the Barrel and Barrel Lug to the Action with Picture
« on: March 31, 2007, 06:40:00 PM »
I am just getting the hang of inserting pictures so I thought some of you may be interested in how easy it is to do this job. It does dedicate the barrel to the action but for us guys in Canada that doesn't matter as we can't participate in the barrel program. If any questions fire away. By the way the pllar bedding and this bedding turned  my Handi into 1 MOA accuracy.

Mc

Offline MSP Ret

  • GBO Supporter
  • Trade Count: (173)
  • Senior Member
  • *****
  • Posts: 8940
  • Gender: Male
Re: Bedding the Barrel and Barrel Lug to the Action with Picture
« Reply #1 on: April 01, 2007, 01:46:01 AM »
Hi McLernon, interesting, do you do this do do away with side play in a barrel that otherwise fits the receiver? What is the bedding material and how do you apply and fit it? Do you have any information on removing it at a later date if you decide to use another barrel on that frame? Is that possible and would it leave any residue once removed?....<><.... :)
"Giving up your gun to someone else on demand is called surrender. It means that you have given up your ability to protect yourself to a power that is greater than you." - David Yeagley

Offline McLernon

  • GBO Supporter
  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 1217
Re: Bedding the Barrel and Barrel Lug to the Action with Picture
« Reply #2 on: April 01, 2007, 05:18:56 AM »
Hi MSP RET:

The way the Handi's are built there are no effective side movement bearing surfaces so I bed the lug/barrel in eight locations to at least dampen out lateral vibrations which can adversely affect accuracy.

The bedding material is one part resin, one part hardener and one part aluminum powder.

Before I go any further I check the clearances with eight small bits of Plasticine put at each of the eight locations. I then assemble the barrel and close. When removed the crushed Plasticine tells me how much clearance exists at all eight locations. This information I use to gauge how much epoxy mixture to apply. I clean up and degrease thoroughly, add three layers of masking tape on the underside of the lug to provide clearance when removed after the job is done and then spray my barrel/lug area with Rust-Guard-It so I can get the assembly apart when set. I then apply the epoxy sparingly at the eight locations and firmly snap the barrel in place.

I think the epoxy can easily be chiseled off later if you decide to fit another barrel. It could then be steel-wooled clean.


Hope this helps.

Mc