« previous next »
Pages: [1]   Go Down

Author Topic: shavings when loading accubonds  (Read 538 times)

0 Members and 2 Guests are viewing this topic.

Offline 257roberts

  • Trade Count: (0)
  • Member
  • *
  • Posts: 15
shavings when loading accubonds
« on: April 06, 2007, 04:04:07 PM »
Just started loading 308 win. with accubonds. But when seating the bullet sometimes there is a tiny bit of copper shavings,not much just a tiny peace here and there. I full length resize and the brass is brand new winchester brass useing RCBS dies. Never had this happen when reloading 30-30 win. with lee dies. Is there something i am doing wrong or just something that is normal.
Logged

Offline quickdtoo

  • Global Moderator
  • Trade Count: (149)
  • Senior Member
  • *****
  • Posts: 43301
  • Gender: Male
Re: shavings when loading accubonds
« Reply #1 on: April 06, 2007, 04:07:09 PM »
I've seen that with 7mm ABs, I don't have an answer for ya, either! ???

Tim
Logged
"Always do right, this will gratify some and astonish the rest" -  Mark Twain

Offline 257roberts

  • Trade Count: (0)
  • Member
  • *
  • Posts: 15
Re: shavings when loading accubonds
« Reply #2 on: April 06, 2007, 04:30:25 PM »
Thanks for the replay Tim , I will just shoot some and see how they group.
Logged

Offline PaulS

  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 1120
Re: shavings when loading accubonds
« Reply #3 on: April 06, 2007, 09:46:20 PM »
If you chamfer the inside of the case neck you shouldn't get the shavings. just use one of the chamfering tools after you trim the caseand or size it. The bullet should go in easier without shaving the bullet jacket.
Logged
PaulS

Hodgdon, Lyman, Speer, Sierra, Hornady = reliable resources
so and so's pages on the internet = not reliable resources
Alway check loads you find on the internet against manuals.
NEVER exceed maximum listed loads.

Offline bearfat

  • Trade Count: (1)
  • Contributor
  • ***
  • Posts: 417
  • Gender: Male
  • "Nothin but giant rats with stubby little tails"
    • Deer/Bear hunting Northern Minnesota
Re: shavings when loading accubonds
« Reply #4 on: April 07, 2007, 12:52:06 AM »
Have the same thing happen with Nosler .308 200 gr Partitions but not their Ballistic Tip. Have been using them for about 12 years now no prob.
Logged
bearfats cabin:    http://buckmountainchateau.com/

Offline quickdtoo

  • Global Moderator
  • Trade Count: (149)
  • Senior Member
  • *****
  • Posts: 43301
  • Gender: Male
Re: shavings when loading accubonds
« Reply #5 on: April 07, 2007, 05:25:48 AM »
I do chamfer, but don't consider the issue a problem, just a curious anomaly that I've not seen on any other bullet.

Tim
Logged
"Always do right, this will gratify some and astonish the rest" -  Mark Twain
Pages: [1]   Go Up
« previous next »