« previous next »
Pages: [1]   Go Down

Author Topic: scope ring allen size  (Read 493 times)

0 Members and 1 Guest are viewing this topic.

Offline Survivor

  • Trade Count: (0)
  • Avid Poster
  • **
  • Posts: 124
  • Gender: Male
scope ring allen size
« on: November 28, 2007, 04:56:57 PM »
Please excuse my deliberately misplaced post.  I know no better quick-resource than our very own Quick so here goes.  Not directly a Handi question but I'll make it one. 

Of the many Handi's that have been scoped have you found that the allen screws are standerized.  Need an allen spec on a .75" B-Square ring. I want to fabricate a "poor-mans" quick release lever.  The first piece of data is the thread size and then maybe weld a small piece of metal to the screw like a sort of custom, angled lever, a small integral tool really.  It'll be a flashlight mount.
Logged

Offline quickdtoo

  • Global Moderator
  • Trade Count: (149)
  • Senior Member
  • *****
  • Posts: 43301
  • Gender: Male
Re: scope ring allen size
« Reply #1 on: November 28, 2007, 05:01:43 PM »
Most ring cap screws are 6-48, it's a pretty standard size, but the best source for B-Square info would be them. ;)

Tim

http://secure.armorholdings.com/b-square/smarthtml/contact.html
Logged
"Always do right, this will gratify some and astonish the rest" -  Mark Twain

Offline Survivor

  • Trade Count: (0)
  • Avid Poster
  • **
  • Posts: 124
  • Gender: Male
Re: scope ring allen size
« Reply #2 on: November 29, 2007, 01:12:00 PM »
I meant to say the screw that tightens the ring to its rail.  All rings have set screws in the bottom to generate tension against their rails/bases.  I'll be in touch with them of course.  THNX for the link.  All of my rings(3 pr.) share the same allen in the base but not the ring caps.  Go figure.
Logged
Pages: [1]   Go Up
« previous next »