« previous next »
Pages: [1]   Go Down

Author Topic: Stock Interchange ?  (Read 336 times)

0 Members and 2 Guests are viewing this topic.

Offline neophyte

  • Trade Count: (0)
  • Member
  • *
  • Posts: 94
  • Gender: Male
Stock Interchange ?
« on: January 02, 2008, 09:11:36 AM »
Can a laminated handi-rifle stock be made to fit aN USH  12 ga ?  I don't think the buttstock is a problem however is there enough mass in the forearm to inlet for that barrel ?
Logged

Offline Hammerspur

  • Trade Count: (1)
  • A Real Regular
  • ****
  • Posts: 542
  • Gender: Male
Re: Stock Interchange ?
« Reply #1 on: January 02, 2008, 10:02:00 AM »
I just eyeballed some of my extra wood... an old 10 ga. forend (same outer diameter as 12 ga. USH) and a laminated one from an Ultra Hunter Rifle.

It looks do-able to me, but that's just a guess. :-\
Logged
Steve
Quote
Of course guns are dangerous... if they weren't they wouldn't be good for anything!

Offline neophyte

  • Trade Count: (0)
  • Member
  • *
  • Posts: 94
  • Gender: Male
Re: Stock Interchange ?
« Reply #2 on: January 02, 2008, 10:44:49 AM »
Now the question is whether the screw location holding the forearms matches both ?
I can do the barrel inletting so long as it doesn't become larger than the top of the forend ?
Logged

Offline quickdtoo

  • Global Moderator
  • Trade Count: (149)
  • Senior Member
  • *****
  • Posts: 43302
  • Gender: Male
Re: Stock Interchange ?
« Reply #3 on: January 02, 2008, 11:00:44 AM »
You can get the USH forend from H&R, they're a lot longer than a rifle or regular shotgun forend, but the spacer is the same, so you could enlarge the channel of a rifle forend, the stud position is the same. The accessory barrels come with forends. ;)

Tim
Logged
"Always do right, this will gratify some and astonish the rest" -  Mark Twain
Pages: [1]   Go Up
« previous next »