Author Topic: Ruger Bisley (Read 907 times)

daddywpb · « **on:** June 29, 2003, 01:00:16 PM »

I was going to put a spring kit in my Bisley this morning, and ran into a problem. I've taken apart Blackhawks before, but the Bisley doesn't have the two screws on either side of the hammer that you take out to remove the grip frame. The disassembly book that I have, and even the instruction manual that came with the gun say to remove the five screws that hold the grip frame on, but...there are only three. Removing the three doesn't free the grip frame. It looks like the hammer pin is holding it on, but I don't want to guess. Does anyone know how to get the grip frame off so I can replace the trigger spring with the one in the kit? Thanks for the help!
Steve

Lloyd Smale · « **Reply #1 on:** June 29, 2003, 01:12:36 PM »

take the grips off the two screws are hiding in behind them.

daddywpb · « **Reply #2 on:** June 29, 2003, 01:27:51 PM »

Lloyd,
Thank you. Believe it or not, I had the grips off, and never saw those screws after about 30 minutes of frustration. If it had been a snake.....! I guess I shouldn't try to do things like that early in the morning. I put in a 17 pound mainspring, and now I can get the trigger spring in next weekend. Thanks again!
Steve

wyote · « **Reply #3 on:** June 30, 2003, 08:27:48 AM »

Also those 2 screws are allen head screws in case you haven't found out already