Stevens 200 barrels-Interchangeable with Savage's?

[Minnesota1]

I am assuming they are but if I get a Stevens 200  can I get Savage 110 barrels and interchange them?  If I look to some custom barrels do they list them for the stevens or the savage 110?  Are there any limitations or additional drawbacks to swapping barrels?

Thanks,

Bob

[trotterlg]

The barrels are the same.  Only a few of the magnum cal Savages have a larger barrel shank and threads, but mostly they are all the small shank barrels that fit all the .223's to the 30-06's etc.  Short action and long action barrels are the same also and will screw onto either receiver.  Only other thing is that some of the very early 110's had a recessed breach type barrel, like a Remington, but they only lasted a couple of years and now all are flat breach barrels.  Larry

[ncsurveyor]

As Larry says, typically the RUM's and WSM's have a different shank size than other calibers.  Other than that, they should all fit.

It is common for savaholics to get a stevens action for the basis of a custom, as the actions are typically the same as Savages.

The other concern is the bolt head - 0.378 for the .223/.204; 0.473 for pretty much everything else smaller than a magnum.  Like the barrels, these are pretty much user changeable.

JC

[LaOtto222]

As has been stated already about the barrels they are interchangeable. On a Savage the bolt heads are also interchangeable. If you have a 223 and want to change it to a 308, it is possible.  Change the barrel, bolt head and magazine well and presto change O you are now a 308 shooter. At the price of a new Stevens, it may be more cost effective to buy a second gun, but I like to tinker and that has some value to me. I have two Stevens that I have worked on and have the two barrels that came on them plus I have 2 after market barrels that I have added to the mix. I got both of mine through Mid-Way USA and they were listed as 110 barrels. As mentioned already just make sure about action length and shank size. There are lots of possibilities.

[Minnesota1]

Thanks for all the info. 

Where can you get the interchangeable bolt heads? What about the mag well?

Thanks,

Bob

[Davemuzz]

Thanks for all the info. 

Where can you get the interchangeable bolt heads? What about the mag well?

Thanks,

Bob

Check out http://savageshooters.com/index.php for suppliers who can get you larger bolt heads.

For Bolt Face Sizes: (Basically 4 sizes)   
   
0.378   for 222 rim, 204,223,ect
.470-473   for the 22-250, 7-08, 308 and BR sized rims
0.532   for mags, 7RM, 300 WM, ect
0.445   PPC

I hope this helps

Dave

[Bob Tobergte]

Thanks for all the info. 

Where can you get the interchangeable bolt heads? What about the mag well?

Thanks,

Bob