« previous next »
Pages: [1]   Go Down

Author Topic: Barrel lug  (Read 639 times)

0 Members and 1 Guest are viewing this topic.

Offline RWK

  • Trade Count: (2)
  • Contributor
  • ***
  • Posts: 266
Barrel lug
« on: March 11, 2008, 08:36:59 AM »
Has any one taken the barrel lug off and made a sketch of it, with all the deminsions. Rich
Logged

Offline Daniel Laws

  • Trade Count: (15)
  • Avid Poster
  • **
  • Posts: 183
Re: Barrel lug
« Reply #1 on: March 13, 2008, 01:53:43 AM »
I asked this question a while back, nobody would admit to ever doing so.  I've threatened it, just don't have a barrel I am willing to mess up to do so.  How about it, anybody got a junk barrel they are willing to give up?  I can draw it up and will publish results.  I have access to optical comparitors, CMM equipment, and all kinds of other fancy stuff at work.  I also had 2 yrs of drafting in college, on my way to an Engineering degree.
Logged

Offline trotterlg

  • GBO Supporter
  • Trade Count: (36)
  • Senior Member
  • *****
  • Posts: 3978
  • Gender: Male
Re: Barrel lug
« Reply #2 on: March 13, 2008, 06:44:14 AM »
I don't think there is any measurement that cannot be taken with the lug still on the barrel.  Larry
Logged
A gun is just like a parachute, if you ever really need one, nothing else will do.

Offline RWK

  • Trade Count: (2)
  • Contributor
  • ***
  • Posts: 266
Re: Barrel lug
« Reply #3 on: March 13, 2008, 08:58:43 AM »
Dan L. can you make up a good print. Rich
Logged

Offline Daniel Laws

  • Trade Count: (15)
  • Avid Poster
  • **
  • Posts: 183
Re: Barrel lug
« Reply #4 on: March 14, 2008, 11:32:33 AM »
I've been drawing stuff up for 25 years and submitting it to machine shops for quotes.  So yes, I can.
Logged

Offline AKbuilder

  • Trade Count: (0)
  • Member
  • *
  • Posts: 30
Re: Barrel lug
« Reply #5 on: March 14, 2008, 01:51:47 PM »
Daniel Laws,
If you just draw the lug part, I would like a copy.  I don't really need it, but it wouldn't hurt to have a good quality print.  I bet it will much better than anything I can cook up.

Thanks,
Paul
Logged

Offline Daniel Laws

  • Trade Count: (15)
  • Avid Poster
  • **
  • Posts: 183
Re: Barrel lug
« Reply #6 on: March 15, 2008, 02:11:42 AM »
The next time I see a CHEAP H&R shotgun at a flea market, I'm going to buy it.  Just to check out the underlug.  There are too many little nooks and crannies in the lug assembly to trust some of the measurements while mounted on a barrel.  I've looked, believe me, and I don't think it is practical unless the lug can be removed.    I think one of the older ones, with the silver soldered lug, would be easier to remove.  Once again, if anybody has a bent, broken or battered barrel, I'd like to have it just for this purpose.
Logged
Pages: [1]   Go Up
« previous next »