« previous next »
Pages: [1]   Go Down

Author Topic: Hornady Presses  (Read 331 times)

0 Members and 2 Guests are viewing this topic.

Offline Pumah25

  • Trade Count: (9)
  • Avid Poster
  • **
  • Posts: 109
Hornady Presses
« on: August 22, 2008, 06:44:12 AM »
I purchased a Hornady single stage press awhile back and now am looking at stepping up to a progressive press. Will the dies that I have set for the single stage be correctly set for the new press or are they set up different. Both are the lock and load.
Logged

Offline stimpylu32

  • Moderators
  • Trade Count: (67)
  • Senior Member
  • *****
  • Posts: 6062
  • Gender: Male
Re: Hornady Presses
« Reply #1 on: August 22, 2008, 07:21:11 AM »
You will probably need to adjust the dies as the diffrent presses will have a diffrent head thickness so the setup will be the same , but you will just need to tweak the up / down till you get to the spot were you want as far as seating depth and crimp , if you need to crimp .

I really don't think that you will be able to just swap out he L&L bushings and have them set to load .

stimpy
Logged
Deceased June 17, 2015


:D If i can,t stop it with 6 it can,t be stopped

Offline Pumah25

  • Trade Count: (9)
  • Avid Poster
  • **
  • Posts: 109
Re: Hornady Presses
« Reply #2 on: August 22, 2008, 09:41:57 AM »
Thank you Stimpy. This was the answer I was looking for. It is what I expected but I had to hope.
Logged
Pages: [1]   Go Up
« previous next »