Author Topic: barrel length  (Read 744 times)

0 Members and 1 Guest are viewing this topic.

Offline PromiseKeeper

  • Trade Count: (0)
  • Posts: 2
barrel length
« on: October 06, 2008, 07:19:00 PM »
Hi,
I'm looking to buy a G2 in 410 for hunting. How important is barrel length? Please give pros and cons. Thanks!

Scott

Offline Ladobe

  • Trade Count: (91)
  • Senior Member
  • *****
  • Posts: 3193
Re: barrel length
« Reply #1 on: October 06, 2008, 09:40:11 PM »
Barrel length can be pretty important depending on what you want to hunt with it.   In you want to shoot handgun config with the 10"-12" barrels your shots will have to be kept shorter to be effective (the 16" barrels are awkward in handgun mode).   It's much easier to make good and longer shots with the longer barrel/stock set of the shotgun config.   Classic VR 410 only barrels were 21" - assume G2 are 23".

I've been a serious handgun hunter since the mid-late 60's, but the 410 is a different animal in a handgun for me.   I didn't do too bad with a 10" VR barrel on jump-shot cottontails and jack rabbits in thick cover, scored a few quail, grouse and pheasants with it, but I can still hear the doves laughing at me from the time I took it out for the opener of dove season about 25 years ago.   Something like 2 boxes of shells and not a single feather.   I sold off the 10" and bought a 21" VR to replace it for my Classic Contenders, and it scores much better on all species for me, very well on some of them and shooting clays. 

So, while the handgun 410 barrels are fun to play with, they leave a lot to be desired for hunting IMO.

Evolution at work. Over two million years ago the genus Homo had small cranial capacity and thick skin to protect them from their environment. One species has evolved into obese cranial fatheads with thin skin in comparison that whines about anything and everything as their shield against their environment. Meus

Offline blhof

  • Trade Count: (0)
  • A Real Regular
  • ****
  • Posts: 738
Re: barrel length
« Reply #2 on: October 07, 2008, 02:39:07 AM »
I 2nd that about the handgun barrel.  I thought that I had to have one for my contender until I tried a friend's and at a mere 10yds the 12" pattern covered a 3' by 3' board with little density.  Anything past 6 or so yds is a lucky shot and possible wound.  The pistol barrels are rifled and must use a choke device that is supposed to take out the spin from the rifling,  It can shoot 45LC but those weren't real accurate either and you must remember to never shoot the 45 with the choke in.

Offline Ken ONeill

  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 1259
  • Gender: Male
Re: barrel length
« Reply #3 on: October 07, 2008, 02:58:20 AM »
My 14" barrel (~2004 vintage) retains very good patterns out to 20 yds. with #6 shot, although I had to experiment with different brands of ammo to find an acceptable combo. It's still barely adequate at about 25 yds., although density has really fallen of by then. I use mine for early season squirrels. I have a friend with a 10" barrel and his pattern density is at least as good, but probably a bit denser than my barrel's.
My skill at bird shooting is approximately equal to the average 2 year old's, so I haven't tried it on any.

Offline PromiseKeeper

  • Trade Count: (0)
  • Posts: 2
Re: barrel length
« Reply #4 on: October 07, 2008, 08:45:16 AM »
Thanks Guys,
I'm going to use it to hopefully shoot some bunnies. Thought it would be a challenge. From what you're saying the 10 or the 14 would work? I really am not interested in making it a long gun....that's what I was trying to avoid in the first place ;) 20 yard shots or so is just what I am looking for.

Scott