Author Topic: model 44 question  (Read 826 times)

0 Members and 2 Guests are viewing this topic.

Offline Scibaer

  • Central Michigan, USA, Earth
  • Trade Count: (25)
  • Senior Member
  • *****
  • Posts: 1686
  • FATE FAVORS THE WISE
model 44 question
« on: October 29, 2008, 02:36:05 PM »
i got a model 44 in .44 mag, 4 inch barrel, like NIB in a trade.
i plan on using it for hunting. question, how hot can i reload for this ? i was concidering a 245gr. swc and around 9 or 10grs. of titegroup.. for 1175fps..
 should be ok ?

Offline Graybeard

  • Administrator
  • Trade Count: (69)
  • Senior Member
  • *****
  • Posts: 26939
  • Gender: Male
Re: model 44 question
« Reply #1 on: October 30, 2008, 03:54:15 AM »
You can safely load it to SAAMI max that means all reloading manual supplied data should be safe. Internet data might not be but then some internet supplied loads aren't safe in anything.

I hope yours is better than mine. The M44 I bought new in box tossed two of six bullets from each cylinder full side ways thru the target at 25 yards, two more clearly were yawing and then two of them made round holes as all six should have.

I had the dealer ship it back for me and then convinced him to accept the replacement that would eventually return to him as a trade in and bought me another brand.


Bill aka the Graybeard
President, Graybeard Outdoor Enterprises
256-435-1125

I am not a lawyer and do not give legal advice.

Jesus is the way, the truth, and the life anyone who believes in Him will have everlasting life!

Offline Scibaer

  • Central Michigan, USA, Earth
  • Trade Count: (25)
  • Senior Member
  • *****
  • Posts: 1686
  • FATE FAVORS THE WISE
Re: model 44 question
« Reply #2 on: October 30, 2008, 02:28:04 PM »
I know your lack of fondness for Taurus'. i can appreciate that too. i dunno how its gonna shoot, the guy i got it from bought it new and seemed to like it.
 if it keyholes then its back into trade off circulation, we'll see i just did want to load up for it and have it shoot loose, my other taurus ( model 606 ) .357 is a great gun, im hoping this one folllows suit.
glenn

Offline Ak.Hiker

  • Trade Count: (0)
  • Contributor
  • ***
  • Posts: 389
Re: model 44 question
« Reply #3 on: October 31, 2008, 06:11:08 PM »
My model 44 is a good shooter. The owners manuel did say to stick to standard weight bullets. I have run some CorBon 305 grain Penetrators with out any problem. I do pretty much stick to 240 to 250 grain loads. Handloads I keep below max. If I want to shoot the heavy weight loads I shoot the Super BlackHawk.

Offline Scibaer

  • Central Michigan, USA, Earth
  • Trade Count: (25)
  • Senior Member
  • *****
  • Posts: 1686
  • FATE FAVORS THE WISE
Re: model 44 question
« Reply #4 on: November 02, 2008, 02:55:36 AM »
i ended up with a  240 gr. xtp over 20 grs. of IMR 4227 with CCI 300 primers. i rolled up 100 count of these, should be ok in the gun and should take a whitetail fine if i do my part. i dont want to hammer the gun and these should be just fine, right out of the Lyman book, but i used R-P brass
i need a contender  ;D

Offline SwampThing762

  • Trade Count: (10)
  • Senior Member
  • *****
  • Posts: 2371
Re: model 44 question
« Reply #5 on: November 04, 2008, 03:28:46 AM »
The Model 44 tracker manual says the highest level load is a 240 grain bullet at 1350 fps.   I think your best bets will be a 240 at 1200, esp with a cast keith-design bullet, and a 300 grain pill at 1100 fps.    The loads are conservative, yes, but they will do the job on deer and hogs.  My Tracker has killed 2 hogs with Winchester USA 240 gr JSPs, and hogs are built a little tougher than deer.

ST762
We learned the true nature of Islam on 11 Sept 2001.

Show your appreciation for Islam....eat more bacon.

"Non nobis Domine, non nobis, sed nomini tuo da gloriam." (Not to us Lord, not us, but to your name give the glory)  -- Knights Templar motto