« previous next »
Pages: [1]   Go Down

Author Topic: DRUM VENTING  (Read 571 times)

0 Members and 2 Guests are viewing this topic.

Offline BJ

  • Trade Count: (3)
  • Member
  • *
  • Posts: 38
  • Gender: Male
DRUM VENTING
« on: November 14, 2008, 12:57:42 PM »
I have read in several publications about "venting" the drum by drilling a small hole in the drum between the nipple and the barrel.  This supposed to make ignition " 'bout foolproof", by allowing the air to be expelled by the flame.  I would be interested in your comments and thoughts, pros and cons, etc.  Thanks.
Logged

Offline captchee

  • Trade Count: (0)
  • Contributor
  • ***
  • Posts: 432
Re: DRUM VENTING
« Reply #1 on: November 14, 2008, 02:22:05 PM »
 as i understand it , this was  based on the theory in front of the heat and gas wave from the cap , is an area of pressure that builds and slows the ignition down  . Venting the drum  is said to have   fixed this ????
 I know of a couple folks that have the drum vented and I have done it for a few rifles that  customers have requested it done . Personally I see no real improvement
 Interesting enough , there were also vent liners for flint locks that  had a double flash hole for this very reason
Logged

Offline bluecow

  • Trade Count: (0)
  • Contributor
  • ***
  • Posts: 250
Re: DRUM VENTING
« Reply #2 on: November 15, 2008, 04:07:24 AM »
I've seen this re comended in a couple of publications, never saw any reason to do so. all the caplocks that I've owned have worked just fine.  ( when keep clean, maintained and loaded with the powder first not the ball0
Logged
Everything before BUT is B.S.
Pages: [1]   Go Up
« previous next »