« previous next »
Pages: [1]   Go Down

Author Topic: 32. Winchester Handi  (Read 278 times)

0 Members and 1 Guest are viewing this topic.

Offline kenbev

  • Trade Count: (30)
  • Contributor
  • ***
  • Posts: 485
32. Winchester Handi
« on: December 30, 2008, 12:38:46 PM »
What are your thoughts. It would probably need to be a stub job. I think I want one...
Logged

Offline stimpylu32

  • Moderators
  • Trade Count: (67)
  • Senior Member
  • *****
  • Posts: 6062
  • Gender: Male
Re: 32. Winchester Handi
« Reply #1 on: December 30, 2008, 02:12:11 PM »
KenBev

From looking at the case drawings you should be able to bore a 30/30 barrel up to .322 and just use a 32 Win. Spl. reamer to clean up the neck area . It would be cheaper than a stub project but still not dirt cheap .

stimpy
Logged
Deceased June 17, 2015


:D If i can,t stop it with 6 it can,t be stopped

Offline brennemanj83

  • Classified -- Banned
  • Trade Count: (3)
  • Contributor
  • *
  • Posts: 362
  • Gender: Male
Re: 32. Winchester Handi
« Reply #2 on: December 30, 2008, 02:21:58 PM »
I'm with Stimpy on this....I think a 30/30 barrel rebored and chambered would be more cost effective and look better.As far as the 32 winchester...I think it would be a good choice.I once had A Winchester 94 chmbered in that round and it was sweet shooter.Wish I had never gotten rid of it.
Logged
Banned for less than honest trading practices.
Pages: [1]   Go Up
« previous next »