« previous next »
Pages: [1]   Go Down

Author Topic: C.E Harris designed bullets  (Read 759 times)

0 Members and 2 Guests are viewing this topic.

Offline WayneS

  • Trade Count: (13)
  • Contributor
  • ***
  • Posts: 490
C.E Harris designed bullets
« on: January 12, 2009, 03:40:05 AM »
Anyone tried the 160 gn SP bullet designed by C.E Harris in a Contender or other .308 bore firearms ??
Logged

Offline Nobade

  • Trade Count: (2)
  • Senior Member
  • *****
  • Posts: 1927
Re: C.E Harris designed bullets
« Reply #1 on: January 13, 2009, 02:02:03 AM »
Sure, I have a 6 cavity mould for those and probably shoot more of them in 30 cal rifles than any other bullet. It works great in everything I've tried so far. Most factory 30's have a .311 or so throat, so I size them to that and get very good results. They even shoot fine in my Marlin 336, loaded singly.
Logged
"Give me a lever long enough, and a place to stand, and I'll break the lever."

Offline WayneS

  • Trade Count: (13)
  • Contributor
  • ***
  • Posts: 490
Re: C.E Harris designed bullets
« Reply #2 on: January 13, 2009, 03:08:56 AM »
Noblade,
Thanks, where did you get your 6 cavity mold ?
Logged

Offline Nobade

  • Trade Count: (2)
  • Senior Member
  • *****
  • Posts: 1927
Re: C.E Harris designed bullets
« Reply #3 on: January 16, 2009, 05:01:39 PM »
It was a group buy over on cast boolits about 7 or 8 years ago. I think they did another run of those not too long ago, there may be one out there somewhere.
Logged
"Give me a lever long enough, and a place to stand, and I'll break the lever."
Pages: [1]   Go Up
« previous next »