« previous next »
Pages: [1]   Go Down

Author Topic: Colt gunsmith???  (Read 1275 times)

0 Members and 1 Guest are viewing this topic.

Offline oldsmokeyjeff

  • Trade Count: (0)
  • Member
  • *
  • Posts: 31
  • Gender: Male
Colt gunsmith???
« on: February 01, 2009, 06:18:15 AM »
Howdy all!
  Have a old Colt Model 357 that I gave my wife about 20 years ago and looking for a good gunsmith to re-time the gun.  If it is cocked slow the cyl doesn't lock and while it is not a problem when cocking normally I still want to fix it.  Also figure that a good going through and tune up is due.  I also would like to do a round butt conversion to fit her hand better and am not worried about hurting the value as it won't be sold in the next 2 lifetimes.  Colt never stamped the "rampant colt" on the side though so any comments on this would be welcomed.  It does have some small pitting on a few areas from holster wear in a humid environment from the previous owner so like I said, I am not too concerned about hurting the value.
  Can anybody steer me to a good Colt smith?
                                                                                      Thanks!
                                                                                                    Jeff
Logged

Offline thickstrings

  • Trade Count: (0)
  • Member
  • *
  • Posts: 16
  • Gender: Male
Re: Colt gunsmith???
« Reply #1 on: February 05, 2009, 03:59:07 AM »
 I also have one of these,allthough the timing on mine is OK,I wanted a re blue, tune-up...so I have asked around,and the consensus was to send the gun to Colt....Apparently , the trigger ,timing of the Colt is a little more specialized. Any gunsmith who works on these should be Colt sanctioned........so Just send it to Colt.
Logged

Offline thickstrings

  • Trade Count: (0)
  • Member
  • *
  • Posts: 16
  • Gender: Male
Re: Colt gunsmith???
« Reply #2 on: February 05, 2009, 04:05:36 AM »
 Upon reading your post again,DUH! I don't think Colt will modify the grip, but they can fix the timing.  By the way, if you have the original grips, They are hard to come by, I know, I have been looking.$$$
Logged

Offline sixgun_symphony

  • Trade Count: (0)
  • Avid Poster
  • **
  • Posts: 162
  • Gender: Male
  • Rabid, Avid Shooter
    • http://www.myspace.com/sixgun_symphony
Re: Colt gunsmith???
« Reply #3 on: April 18, 2009, 01:12:36 AM »
 I sent in my 1878 Colt DA Frontier .45 revolver to Dwight at A & J Gunsmithing.  He has also worked on my Colt Official Police, Colt .357, and Colt Police Positive Special revolvers.

 A & J Gunsmithing
(206) 244-0669
708 Sw 158th St, Burien, WA 98166

 
Logged
NRA - Endowment Life Member
NMLRA - Life Member
SASS - #62632
Pages: [1]   Go Up
« previous next »