Author Topic: My PF9 mag only takes 6 rounds (Read 1336 times)

smong2000 · « **on:** August 03, 2009, 01:57:14 AM »

Anyone else have trouble getting 7 in? Feels like a hard stop to me and I hate to break it. Should it be that tight?

Thanks

canon6 · « **Reply #1 on:** August 03, 2009, 03:20:55 AM »

Of the three mags I have, two of them, took a lot of force at first.I just keep loading them with as many as they would hold, and they finally lossened up. hth Doug

Savage · « **Reply #2 on:** August 04, 2009, 01:29:24 AM »

Wouldn't hurt to disassemble the magazine and check it for burrs and cleanliness. If all is well just stuff in that 7th round!
Savage

smong2000 · « **Reply #3 on:** August 05, 2009, 05:36:44 AM »

Thanks guys. Keltec CS told me to take it apart, clean and lube it as well.

Savage · « **Reply #4 on:** August 05, 2009, 06:47:31 AM »

Use a good dry lube inside the magazine tube. Anything else attracts crud. Make sure the follower has no rough edges or flashing as well.
Savage

smong2000 · « **Reply #5 on:** August 06, 2009, 02:57:17 AM »

When I took it apart the spring was not captured in the recess at the bottom of the follower. Simple fix, hold the spring upright, drop the follower on it, lower the mag case on so the spring stays in the follower while you slide the bottom finger guard or std cap in place. The extra inch made a world of difference, now it loads 7 the way I'd expect it to.

Author Topic: My PF9 mag only takes 6 rounds (Read 1336 times)

smong2000

My PF9 mag only takes 6 rounds

canon6

Re: My PF9 mag only takes 6 rounds

Savage

Re: My PF9 mag only takes 6 rounds

smong2000

Re: My PF9 mag only takes 6 rounds

Savage

Re: My PF9 mag only takes 6 rounds

smong2000

Re: My PF9 mag only takes 6 rounds -FIXED IT