« previous next »
Pages: [1]   Go Down

Author Topic: NitroSteel's 30mm mould...  (Read 359 times)

0 Members and 1 Guest are viewing this topic.

Offline Victor3

  • GBO Supporter
  • Trade Count: (22)
  • Senior Member
  • *****
  • Posts: 4241
NitroSteel's 30mm mould...
« on: July 07, 2009, 02:29:49 AM »
 Just finished it up...



 Some folks have asked me to make these. Wish I could, but I don't have the time. Maybe some day...
Logged
"It is a capital mistake to theorize before one has data. Insensibly, one begins to twist facts to suit theories, instead of theories to suit facts."

Sherlock Holmes

Offline cannonmn

  • Trade Count: (1)
  • Senior Member
  • *****
  • Posts: 3345
Re: NitroSteel's 30mm mould...
« Reply #1 on: July 07, 2009, 03:41:28 AM »
Looks great, let us know how well it works out when you start casting with it.
Logged

Offline NitroSteel

  • Trade Count: (2)
  • Avid Poster
  • **
  • Posts: 208
Re: NitroSteel's 30mm mould...
« Reply #2 on: July 07, 2009, 03:44:18 PM »
Victor,

You are the MAN... ;)
Logged

Offline Victor3

  • GBO Supporter
  • Trade Count: (22)
  • Senior Member
  • *****
  • Posts: 4241
Re: NitroSteel's 30mm mould...
« Reply #3 on: July 08, 2009, 01:01:15 AM »
 Here's a slug next to a 40mm ball (they didn't come out clean since I was using my little Lyman bottom-discharge pot and moulds were not hot enough).

 30mm slug weighs 3465 grains. 1.735" OAL.

Logged
"It is a capital mistake to theorize before one has data. Insensibly, one begins to twist facts to suit theories, instead of theories to suit facts."

Sherlock Holmes
Pages: [1]   Go Up
« previous next »