« previous next »
Pages: [1]   Go Down

Author Topic: 5mm Centerfire  (Read 412 times)

0 Members and 1 Guest are viewing this topic.

Offline JRiddle

  • Trade Count: (14)
  • Avid Poster
  • **
  • Posts: 244
  • Gender: Male
5mm Centerfire
« on: August 27, 2009, 05:14:40 AM »
I was reading about a process that uses 22 hornet brass, trimmed and necked to make 5mm centerfire brass.  I was wondering if anyone here has done it?  And if so...is it worth it?  Compared to buying the original rimfire ammo (when you can find it).  This is for a T/C barrel, so the bolt change in a rifle is a non-issue.  Thanks, JR
Logged
"Give me Liberty...or I'll get up, and get it myself."

Offline Graybeard

  • Administrator
  • Trade Count: (69)
  • Senior Member
  • *****
  • Posts: 26922
  • Gender: Male
Re: 5mm Centerfire
« Reply #1 on: August 27, 2009, 09:04:23 AM »
Not sure but don't think that's the way it's done. The guy who does the centerfire conversions sells the proper brass and dies as well.
Logged


Bill aka the Graybeard
President, Graybeard Outdoor Enterprises
256-435-1125

I am not a lawyer and do not give legal advice.

Jesus is the way, the truth, and the life anyone who believes in Him will have everlasting life!

Offline SHOOTALL

  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 23836
Re: 5mm Centerfire
« Reply #2 on: August 27, 2009, 09:08:39 AM »
5mm rimfire is everwhere now , even the gun shows . Its imported but aval. if none in your area check out cheaper than dirt
Logged
If ya can see it ya can hit it !
Pages: [1]   Go Up
« previous next »