« previous next »
Pages: [1]   Go Down

Author Topic: 1894 Magazine Capacity  (Read 682 times)

0 Members and 1 Guest are viewing this topic.

Offline Drollerindy

  • Trade Count: (1)
  • Member
  • *
  • Posts: 66
  • Gender: Male
1894 Magazine Capacity
« on: October 28, 2009, 09:49:38 AM »
I was loading Hornady LeveRevolution .44 Magnums in my 1894 last night and try as I might, I could get only nine to fit in the magazine. The tenth round went about half-way and stopped. I thought it was a ten round magazine. Is something wrong?

Doug
Logged

Offline .357 shooter

  • Trade Count: (0)
  • Member
  • *
  • Posts: 81
  • Gender: Male
Re: 1894 Magazine Capacity
« Reply #1 on: October 29, 2009, 06:50:58 AM »
The tube holds 9 plus 1 in chamber.



Bryan
Logged
New York State! Home of high Taxes......

Offline HL

  • Trade Count: (0)
  • Contributor
  • ***
  • Posts: 404
Re: 1894 Magazine Capacity
« Reply #2 on: October 29, 2009, 09:32:04 AM »
My 1894, 44 mag will hold 10 in the tube. It may be with the spitzer bullets, the additional length of the bullets is not allowing that 10th. Check the overall length of the LeveRevolution rounds against the overall length of FN rounds. I bet there's a little difference, at least enough to make up the half round.

this is what I found on the marlin website as per specifications for the 1894. I did not see a copyright, but if its not OK to show this, I apologize in advance GB. Don't want to cause any problems for anyone.

 Caliber 44 Rem. Magnum / 44 S&W Special Order Online from Gallery of Guns
Capacity 10-shot tubular magazine
Action Lever action with squared finger lever; side ejection; stainless steel receiver, barrel, lever, trigger guard plate, magazine tube and loading gate. Hammer block safety.
Stock Straight-grip American black walnut; cut checkering; rubber rifle butt pad; tough Mar-Shield® finish; nickel-plated steel fore-end cap; swivel studs.
Barrel 20" with deep-cut Ballard-type rifling (6 grooves).
Twist Rate  1:38" r.h.
Sights Adjustable semi-buckhorn folding rear, ramp front sight with brass bead and Wide-Scan™ hood. Solid top receiver tapped for scope mount; offset hammer spur (right or left hand) for scope use. 
Overall Length 37.5" 
Weight 6 lbs. 
Logged

Offline Drollerindy

  • Trade Count: (1)
  • Member
  • *
  • Posts: 66
  • Gender: Male
Re: 1894 Magazine Capacity
« Reply #3 on: November 01, 2009, 05:49:31 PM »
Printed specifications are one thing, actual fact is sometimes another.

I request that 1894 owners try stuffing their magazines and report back on observed capacity.
And if everybody else gets 10 rounds in theirs, please help me figure out why mine stops at nine.

Thanks,
Doug
Logged

Offline Graybeard

  • Administrator
  • Trade Count: (69)
  • Senior Member
  • *****
  • Posts: 26945
  • Gender: Male
Re: 1894 Magazine Capacity
« Reply #4 on: November 02, 2009, 02:29:27 AM »
Folks using lever rifles in CAS competition MUST load ten rounds in their magazines. Many use Marlin 1894s in .45 Colt which is the same length as a .44 magnum tho I suspect few use .44 mags as they would have to be loaded real light to meet velocity requirements so .44 specials would more likely be used. But .357 Mag is same length and is used as are .38 specials.

Bottom line is that most any Marlin with a 20" or longer barrel should hold ten rounds in the magazine. If yours won't then it is a problem unique to that rifle or the ammo you are trying to use.
Logged


Bill aka the Graybeard
President, Graybeard Outdoor Enterprises
256-435-1125

I am not a lawyer and do not give legal advice.

Jesus is the way, the truth, and the life anyone who believes in Him will have everlasting life!

Offline Drollerindy

  • Trade Count: (1)
  • Member
  • *
  • Posts: 66
  • Gender: Male
Re: 1894 Magazine Capacity
« Reply #5 on: November 02, 2009, 02:40:43 AM »
My 46th edition Lyman reloading manual (so old it is on papyrus...) shows the OAL for .44 Mag to be 1.610.
The LeveRevolution ammo measures 1.642. 0.032 X 9 = 0.288 inch. Not quite 1/3 inch. More than 1/3 inch of the round was sticking out of the loading gate.
I don't see that as enough to reduce capacity by one round. It must be a problem with the gun.
Maybe the spring is not fully seated in the magazine follower or maybe the spring is too long. Any other ideas?
Doug
Logged

Offline 454Puma

  • Trade Count: (1)
  • A Real Regular
  • ****
  • Posts: 539
Re: 1894 Magazine Capacity
« Reply #6 on: November 04, 2009, 12:46:42 PM »
Drollerindy
 You wouldn't have a Komifornia gun would you? I know they don't like anything over 10 round mags?   ???
Logged
One shot , One Kill

Offline Drollerindy

  • Trade Count: (1)
  • Member
  • *
  • Posts: 66
  • Gender: Male
Re: 1894 Magazine Capacity
« Reply #7 on: November 04, 2009, 04:52:47 PM »
No, my gun was made in 1975. I think that was before California became a Peoples Republic.

Doug
Logged
Pages: [1]   Go Up
« previous next »