« previous next »
Pages: [1]   Go Down

Author Topic: Endeavor ML hammer locks up  (Read 430 times)

0 Members and 1 Guest are viewing this topic.

Offline okie

  • Trade Count: (3)
  • Member
  • *
  • Posts: 23
Endeavor ML hammer locks up
« on: October 12, 2009, 12:11:42 PM »
I recently purchased a new Encore Endeavor ML and after a few shots when a new 209 primer is loaded, the hammer freezes up and will not cock. I have to open and close it a few times before it will finally release. I am using Winchester primers. Has  anyone had this problem and figured out a solution . Any help would be greatly appreciated. The barrel shoots less than a minute of angle accuracy and would definitely be a keeper if not for this problem.
Logged

Offline Encore28

  • Trade Count: (0)
  • Contributor
  • ***
  • Posts: 332
Re: Endeavor ML hammer locks up
« Reply #1 on: October 12, 2009, 02:27:41 PM »
Send it back to T/C they will fix it----------Lifetime warranty!!!

Encore28
Logged
T/C---One Perfect Shot

TCA Member

Offline TRM-1

  • Trade Count: (13)
  • Contributor
  • ***
  • Posts: 286
  • Gender: Male
Re: Endeavor ML hammer locks up
« Reply #2 on: October 12, 2009, 02:52:38 PM »
If I understand it will cock fine until you put a primer in it. Well I would try some different primers and see if that made any difference. Then if it didn't I would try another breach plug. call T/C they would probably send you one.
Logged

Offline okie

  • Trade Count: (3)
  • Member
  • *
  • Posts: 23
Re: Endeavor ML hammer locks up
« Reply #3 on: October 13, 2009, 02:24:00 PM »
I called TC today and they told me to try a different brand of primer such as Federal  or  CCI  They said this is a common problem in some Encores due to the Winchester primer being a little larger in  overall length. That being said , I purchased some  Federal 209 A primers  today and the problem was solved. Thanks for everyones help!

Happy Hunting!
Okie
Logged
Pages: [1]   Go Up
« previous next »