« previous next »
Pages: [1]   Go Down

Author Topic: Bushnell Elite 3200 10X question  (Read 534 times)

0 Members and 3 Guests are viewing this topic.

Offline JKF59

  • Trade Count: (0)
  • Member
  • *
  • Posts: 22
Bushnell Elite 3200 10X question
« on: December 14, 2009, 12:57:26 PM »
I just received a Bushnell Elite that I purchased from Graybeard. My question is can you set the target knobs to zero after sighting in the rifle? The booklet that came with it says that you can do it on the regular knobs but makes no mention of the target knobs.
Logged

Offline mrbigtexan

  • Trade Count: (7)
  • A Real Regular
  • ****
  • Posts: 594
Re: Bushnell Elite 3200 10X question
« Reply #1 on: December 14, 2009, 04:30:40 PM »
yes, that way when adjusted for elevation and wind drift, they can be put back on zero.
Logged

Offline JKF59

  • Trade Count: (0)
  • Member
  • *
  • Posts: 22
Re: Bushnell Elite 3200 10X question
« Reply #2 on: December 15, 2009, 12:10:00 AM »
Thanks mrbigtexan. Could you tell me how to do it? I see a hole in the top of each knob but it doesnt look like a screw in the hole. Maybe it is.
Logged

Offline TLARbb

  • Trade Count: (3)
  • Contributor
  • ***
  • Posts: 276
Re: Bushnell Elite 3200 10X question
« Reply #3 on: December 20, 2009, 03:06:53 AM »
Most likely it is a hex socket for hex key wrench.  Take the top retainer screw (large flat headed screw) off,  pull the knob straight up re-position at zero and the put the screw back to hold it in place.

EJ
Logged

Offline mrbigtexan

  • Trade Count: (7)
  • A Real Regular
  • ****
  • Posts: 594
Re: Bushnell Elite 3200 10X question
« Reply #4 on: December 26, 2009, 02:44:10 PM »
how are you liking this scope?
Logged
Pages: [1]   Go Up
« previous next »