www.GBOReloaded.com
Home
Help
Articles
Classifieds
Login
Register
Graybeard Outdoors (GBO Reloaded)
»
Rifle and Optics Forums
»
Optics Discussion
»
leupold problems
« previous
next »
Print
Pages: [
1
]
Go Down
Author
Topic: leupold problems (Read 710 times)
0 Members and 1 Guest are viewing this topic.
qweeksdraw
Trade Count:
(
0
)
Member
Posts: 47
leupold problems
«
on:
December 04, 2009, 12:53:39 AM »
Hi all, I have three leupold scopes- when its cold or you have gloves on, its hard to adjust scope. is there any after market products out that will assist twist ? Thanks for your time.
AND ALSO, IS IT OK TO EAT LEAD?
Logged
Empty Quiver
Trade Count:
(
0
)
Senior Member
Posts: 2847
Re: leupold problems
«
Reply #1 on:
December 04, 2009, 02:42:05 AM »
Yes, a strap wrench. Alternately you can use a set of ten inch water pump pliers. Have you called Leupold?
I know of lots of fish who eat lead and survive to be caught again. Lead based paint chips are all we had as snacks when I was a young'un. The larger the chunk of lead you eat the less relative damage you should expect. A couple BB shot would cause much less concern than equivalent weight powdered into your oatmeal in the morning.
Logged
**Concealed Carry...Because when seconds count help is only minutes away**
bobg
GBO Supporter
Trade Count:
(
8
)
Senior Member
Posts: 1555
Gender:
Re: leupold problems
«
Reply #2 on:
December 04, 2009, 02:50:05 AM »
My answer is about the same as Empty Quivers. Only i was going to say. Sounds like he has already ate to much lead.
bobg
Logged
bluebayou
Trade Count:
(
0
)
Senior Member
Posts: 1216
Gender:
Re: leupold problems
«
Reply #3 on:
December 04, 2009, 04:03:20 AM »
uh........in the spirit of the others:
1. man up
2. loosen it up, sometimes newer scopes are stiff. Maybe you need to sit in front of the tv and work the adjustment collar 100 times to loosen it up a bit.
In the field, just set the scope on the lowest power and/or the AO at 100 yards and leave it alone.
Logged
carbineman
GBO Supporter
Trade Count:
(
58
)
Senior Member
Posts: 1322
Re: leupold problems
«
Reply #4 on:
December 04, 2009, 05:15:12 AM »
A classic Leupold problem. Sometimes a trip to the factory will remedy the problem. Sometimes not. Mine don't seem to be any worse in the cold weather though. After enough turning back and forth all mine loosened up somewhat.
Also you can lead a horse to water, but a pencil must be lead.
Logged
qweeksdraw
Trade Count:
(
0
)
Member
Posts: 47
Re: leupold problems
«
Reply #5 on:
December 06, 2009, 03:06:12 AM »
Thanks for all your input. The one that is the worst was made in the mid 40's the other two are newer. the only time its a problem is when you need to dial up in a hurry to see horns in a cut down. cuz in a cut down they all have horns. ar ar ar.
Logged
squirrellluck
Trade Count:
(
0
)
A Real Regular
Posts: 642
Re: leupold problems
«
Reply #6 on:
December 06, 2009, 07:25:58 AM »
When in doubt about horns, ground check em
Logged
Print
Pages: [
1
]
Go Up
« previous
next »
Graybeard Outdoors (GBO Reloaded)
»
Rifle and Optics Forums
»
Optics Discussion
»
leupold problems