« previous next »
Pages: [1]   Go Down

Author Topic: Mold suggestion for 4" .500 S&W  (Read 471 times)

0 Members and 1 Guest are viewing this topic.

Offline Humbo

  • Trade Count: (0)
  • Avid Poster
  • **
  • Posts: 108
Mold suggestion for 4" .500 S&W
« on: February 13, 2010, 10:52:17 PM »
Hi,
I'm going to start casting for the mighty 500 S&W. This is a new caliber for me, so I could use some pointers. I prefer using gas checks in all magnum handguns, so that's what I'm aiming for. I'm looking for molds that cast in the mid-weight rainge, let's say 350-450 grains or thereabouts. LBT 400 or 440 WFN seem like a couple of good options for an all-rounder, so maybe that's where I'll start.
Are there any decent steel molds for the 500 out there? What diameter do I size to? I don't have the gun before me, so I haven't had the chance to slug it yet.
Thanks.

Humbo
Logged

Offline Nobade

  • Trade Count: (2)
  • Senior Member
  • *****
  • Posts: 1927
Re: Mold suggestion for 4" .500 S&W
« Reply #1 on: February 18, 2010, 02:35:38 PM »
Mountain Molds will make you pretty much anything you want, in aluminum, brass, or iron. Not sure about sizing diameter, you'll have to measure your cylinder throats.
Logged
"Give me a lever long enough, and a place to stand, and I'll break the lever."

Offline Lloyd Smale

  • Moderators
  • Trade Count: (32)
  • Senior Member
  • *****
  • Posts: 18250
Re: Mold suggestion for 4" .500 S&W
« Reply #2 on: February 19, 2010, 01:32:28 AM »
ballistic cast makes a nice 430 grain lfngc mold.
Logged
blue lives matter

Offline Humbo

  • Trade Count: (0)
  • Avid Poster
  • **
  • Posts: 108
Re: Mold suggestion for 4" .500 S&W
« Reply #3 on: February 19, 2010, 05:53:57 AM »
Are the ballist-cast molds worth the $? 150 for a 2-cavity molds seems quite steep. I'm going to slug my gun next weekend when I get home, after that I'll make the final decision. I need at least one LBT mold for my 500 as well.
Logged
Pages: [1]   Go Up
« previous next »