« previous next »
Pages: [1]   Go Down

Author Topic: Model 60 parts question  (Read 472 times)

0 Members and 1 Guest are viewing this topic.

Offline tpic402

  • Trade Count: (0)
  • Member
  • *
  • Posts: 75
Model 60 parts question
« on: March 28, 2010, 11:06:54 AM »
I have a model 60 (plastic trigger guard) the ejector lifter spring has bent (the part of the spring that acts as the ejector pushing on the rim of the shell upon bolt blowback) is this a frequently failing item if it is is there an alternative to this spring??       Thanks Tom 
Logged

Offline EVOC ONE

  • GBO Supporter
  • Trade Count: (3)
  • Senior Member
  • *****
  • Posts: 1373
  • Gender: Male
Re: Model 60 parts question
« Reply #1 on: March 29, 2010, 01:29:42 AM »
If no one here can assist, you may want to check over at www.RimfireCentral.com and look up the Mod 60 forum.

 :)
Logged

Offline Redneck Kyle

  • Trade Count: (0)
  • Posts: 3
Re: Model 60 parts question
« Reply #2 on: April 16, 2010, 05:34:13 PM »
i bent mine two. i looke for a replace ment part and i think brownells has some. mine still works though so its not a big cocern for me
Logged

Offline gunnut69

  • Moderators
  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 5005
Re: Model 60 parts question
« Reply #3 on: April 16, 2010, 05:58:41 PM »
The usual reason is poor reassembly.. Just bend the springs tail back into position. If it fails parts are readily available.. These are great little rifles although the triggers have a few problems.. and they require careful work sequences when repair is needed.. Accuracy is almost always outstanding..
Logged
gunnut69--
The 2nd amendment to the constitution of the United States of America-
"A well regulated militia, being necessary to the security of a free state, the right of the people to keep and bear arms, shall not be infringed."
Pages: [1]   Go Up
« previous next »