« previous next »
Pages: [1]   Go Down

Author Topic: reload 45-70 with 45 colt dies  (Read 509 times)

0 Members and 2 Guests are viewing this topic.

Offline greenmtnboy

  • Trade Count: (19)
  • Contributor
  • ***
  • Posts: 272
  • Gender: Male
reload 45-70 with 45 colt dies
« on: February 09, 2010, 10:03:30 AM »
Can I Resize & reload my 45-70 cases with 45 Colt dies ?
Logged
ROD

Offline billy_56081

  • GBO Supporter
  • Trade Count: (5)
  • Senior Member
  • *****
  • Posts: 8575
  • Gender: Male
Re: reload 45-70 with 45 colt dies
« Reply #1 on: February 09, 2010, 10:21:38 AM »
No.
Logged
99% of all Lawyers give the other 1% a bad name. What I find hilarious about this is they are such an arrogant bunch, that they all think they are in the 1%.

Offline Dezynco

  • Trade Count: (38)
  • A Real Regular
  • ****
  • Posts: 970
Re: reload 45-70 with 45 colt dies
« Reply #2 on: February 09, 2010, 11:18:43 AM »
No because they are two different diameter bullets, and the 45 Colt dies probably won't screw out that far.
Logged

Offline mjbgalt

  • Trade Count: (26)
  • Senior Member
  • *****
  • Posts: 2367
  • Gender: Male
Re: reload 45-70 with 45 colt dies
« Reply #3 on: February 09, 2010, 01:41:59 PM »
i wonder if you could use the .45 colt dies as a sort of neck sizer die for the .45-70?
Logged
I have it on good authority that the telepromter is writing a stern letter.

Offline Autorim

  • Trade Count: (0)
  • A Real Regular
  • ****
  • Posts: 610
  • Gender: Male
Re: reload 45-70 with 45 colt dies
« Reply #4 on: February 09, 2010, 02:18:53 PM »
No.
Logged

Offline greenmtnboy

  • Trade Count: (19)
  • Contributor
  • ***
  • Posts: 272
  • Gender: Male
Re: reload 45-70 with 45 colt dies
« Reply #5 on: February 09, 2010, 02:26:20 PM »
I was thinking on the same line as a neck sizer. But with them being different diameter, which I should have noticed before asking, that wont work.  Thanks for the input guys.
                      Rod
Logged
ROD

Offline Dezynco

  • Trade Count: (38)
  • A Real Regular
  • ****
  • Posts: 970
Re: reload 45-70 with 45 colt dies
« Reply #6 on: February 09, 2010, 04:13:06 PM »
If you are shooting a single shot 45-70, you might consider purchasing a "taper crimp" die.  You can finger seat the bullets, then run the cartridge up into the taper crimp die.  Presto, you have a loaded round!  This may not work in a lever gun because of the need for the cases to feed through the action.

The buffalo hunters just finger seated the bullets and might have pinched the case mouth to hold the bullet in.  But of course they were shooting black powder, which developes a relatively low pressure.
Logged
Pages: [1]   Go Up
« previous next »