« previous next »
Pages: [1]   Go Down

Author Topic: Scope base screw size  (Read 519 times)

0 Members and 2 Guests are viewing this topic.

Offline Birddog 1

  • Trade Count: (2)
  • Avid Poster
  • **
  • Posts: 194
  • Gender: Male
Scope base screw size
« on: May 13, 2010, 03:09:27 PM »
I am wanting to mount a scope base on my barrel but the screws that hold the base in place are a tad bit too long I need to know what size they are so when I shorten them I can get a nut or a thread chaser to clean up the threads. TIA Nim
Logged
If we lose freedom here, there is no place to escape to.
This is the last stand on earth.
R.R. 1964


The strongest reason for the people to retain the right to keep and bear armes is as a last resort, to protect themselves against tyranny in goverment.
Thomas Jefferson

Offline Czech_too

  • Trade Count: (24)
  • Contributor
  • ***
  • Posts: 350
  • Gender: Male
Re: Scope base screw size
« Reply #1 on: May 13, 2010, 03:49:49 PM »
6/48's
Logged
NRA Life Member
Cruffler
INOA

genealogy, another area of interest

Offline hillbill

  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 3285
Re: Scope base screw size
« Reply #2 on: May 13, 2010, 03:51:38 PM »
go to sears or any place that sells a lot of tools and get a thread pitch gauge.that will tell yu the threads per inch or tpi.then go to a hardware store and get a nut the same size if yu can, screw it on and then cut off the screw with a jewlers saw or slowly grind off the excess, being sure to keep the screw cool to not lose any temper it may have.i like then to hit the end of the screw with a belt sander and round off the screw end, then screw off the nut and it should be ready to go.a actual die is usally too thick for these jobs.
Logged

Offline Birddog 1

  • Trade Count: (2)
  • Avid Poster
  • **
  • Posts: 194
  • Gender: Male
Re: Scope base screw size
« Reply #3 on: May 17, 2010, 10:11:29 AM »
I got tired of trying to find some screws that would fit so I called Thompson and even though I didn't buy the mount from them they are sending me 4 of the rwright screws that will fit. Yu got to love the people at TC  ;D

                      Nim
Logged
If we lose freedom here, there is no place to escape to.
This is the last stand on earth.
R.R. 1964


The strongest reason for the people to retain the right to keep and bear armes is as a last resort, to protect themselves against tyranny in goverment.
Thomas Jefferson
Pages: [1]   Go Up
« previous next »