« previous next »
Pages: [1]   Go Down

Author Topic: my p32 "glocks" up my brass!  (Read 1174 times)

0 Members and 1 Guest are viewing this topic.

Offline troy_mclure

  • Trade Count: (10)
  • Avid Poster
  • **
  • Posts: 231
my p32 "glocks" up my brass!
« on: September 27, 2009, 09:55:20 PM »
causes a bulge on the lower end of the shell, looks like its bulging down to the feed ramp.


anybody elses do this?
Logged

Offline Graybeard

  • Administrator
  • Trade Count: (69)
  • Senior Member
  • *****
  • Posts: 26944
  • Gender: Male
Re: my p32 "glocks" up my brass!
« Reply #1 on: September 28, 2009, 03:09:21 AM »
To be honest I've never even bothered looking for the brass from mine. I have no plans to reload for the round so don't even go looking for the brass.
Logged


Bill aka the Graybeard
President, Graybeard Outdoor Enterprises
256-435-1125

I am not a lawyer and do not give legal advice.

Jesus is the way, the truth, and the life anyone who believes in Him will have everlasting life!

Offline markp

  • Trade Count: (0)
  • Avid Poster
  • **
  • Posts: 200
Re: my p32 "glocks" up my brass!
« Reply #2 on: October 01, 2009, 05:15:55 PM »
  My p 3at messes  up the brass somthing terrible. It causes a crease from the center to the mouth with
  the mouth having a flat side. Gun works fine with maybe 175 to 200 rds threw it. 
Logged

Offline Savage

  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 4397
Re: my p32 "glocks" up my brass!
« Reply #3 on: October 11, 2009, 02:24:50 AM »
For the extremely low volume I'm likely to put through any .32/.380, no way I'm chasing brass! So, haven't examaned any of mine.
Savage
Logged
An appeaser is one who feeds the crocodile hoping it will eat him last,

Offline slim rem 7

  • Trade Count: (1)
  • Senior Member
  • *****
  • Posts: 2028
Re: my p32 "glocks" up my brass!
« Reply #4 on: October 11, 2009, 04:27:48 PM »
 you might be shooting that pmc aluminum stuff .. its all i could get at one time.. but i didn t like it so much that what i got left of a box is put away for when theys nothin else to use..casings looked a little rough ..
Logged

Offline troy_mclure

  • Trade Count: (10)
  • Avid Poster
  • **
  • Posts: 231
Re: my p32 "glocks" up my brass!
« Reply #5 on: May 06, 2010, 06:24:11 PM »
id forgotten all about this thread! lol

i figured it out.

i had shot a couple of boxes of rem  umc(which is super dirty) and it caused a build up at the edge of the chamber. thus it was not allowing the round to fully seat.

fixed by very very thorough cleaning.

each gun has its quirks.
Logged
Pages: [1]   Go Up
« previous next »