« previous next »
Pages: [1]   Go Down

Author Topic: First casting  (Read 441 times)

0 Members and 2 Guests are viewing this topic.

Offline Good time Charlie

  • Trade Count: (0)
  • Avid Poster
  • **
  • Posts: 156
First casting
« on: December 03, 2003, 01:54:24 AM »
I cast my first bullets yesterday. Of about 50 or so cast about eight to 10 had gad spurs on top of the bullet like the mold wasn't closing completely. It would happen randomly and the next bullet would be fine. Am I doing something to cause this or is that just part of the game?
                                                  Charlie
Logged

Offline wener

  • Trade Count: (0)
  • Member
  • *
  • Posts: 65
mould
« Reply #1 on: December 03, 2003, 02:25:21 AM »
sounds like your pouring alittle to fast! if not check the mould to make sure its coming together properly may be some burrs around the pin alinment holes. moulds tend to be different  in venting so some you could pour fast some you can pour slow to get a good fill!
Logged

Offline Good time Charlie

  • Trade Count: (0)
  • Avid Poster
  • **
  • Posts: 156
first cast
« Reply #2 on: December 03, 2003, 02:32:41 AM »
I think you hit on it right away about to fast. I was getting a might carried away.
              Charlie
Logged
Pages: [1]   Go Up
« previous next »