« previous next »
Pages: [1]   Go Down

Author Topic: Stevens 22-410 firing pin alignment  (Read 389 times)

0 Members and 1 Guest are viewing this topic.

Offline wileynet

  • Trade Count: (30)
  • Contributor
  • ***
  • Posts: 378
  • Gender: Male
Stevens 22-410 firing pin alignment
« on: September 13, 2010, 07:16:59 AM »
any solutions appreciated, just changed firing pin and spring. 22 wont fire put a piece of foil in the action and firing pin is hitting just below the rim of the case any solutions
Logged
"The beauty of the second amendment is that it will not be needed until they try to take it." -Thomas Jefferson

Huntsman 58,NEF 45/70 manlicher stock, H&R 308, 30-06, 12 ga, 20 ga, H&R 223, H&R 204 varmiter,H&R 243, H&R 44mag, SMLE No 1 MKIV,SMLE No4 MK1, Savage 110 7mm, Ruger BH 45LC, Security Six, SR9, S&W 22a, CVA MTN Rifle, Optima

Offline tacklebury

  • GBO Supporter
  • Trade Count: (12)
  • Senior Member
  • *****
  • Posts: 3633
  • Gender: Male
  • Central Michigan
Re: Stevens 22-410 firing pin alignment
« Reply #1 on: September 13, 2010, 04:05:43 PM »
Perhaps a drop of solder just where the flip lever rests.  Might bring it up a bit, just don't go crazy and let a bunch run inside the housing.  8)
Logged
Tacklebury --}>>>>>    Multi-Barrel: .223 Superlite, 7mm-08 22", .30-40 Krag M158, .357 Maximum 16-1/4 HB, .45 Colt, .45-70 22" irons, 32" .45-70 Peeps, 12 Ga. 3-1/2 w/ Chokes, .410 Smooth slugger, .45 Cal Muzzy, .50 Cal Muzzy, .58 Cal Muzzy

also classics: M903 9-shot Target .22 Revolver, 1926 .410 Single, 1915 38 S&W Break top Revolver and 7-shot H&R Trapper .22 6" bbl.

Pages: [1]   Go Up
« previous next »