« previous next »
Pages: [1]   Go Down

Author Topic: 3/16 dove tail to 3/8 dovetail  (Read 495 times)

0 Members and 1 Guest are viewing this topic.

Offline wileynet

  • Trade Count: (30)
  • Contributor
  • ***
  • Posts: 378
  • Gender: Male
3/16 dove tail to 3/8 dovetail
« on: September 13, 2010, 07:49:08 PM »
have Stevens model 22-410 so far i have purchased 4 different 3/16 dovetail rear sights they refuse to stay in, would like to cut 3/8 dove tail for some of the fold down rear sights, how hard is it to re-cut the dovetail, no gunsmiths in my neck of the woods any help would be appreciated
Logged
"The beauty of the second amendment is that it will not be needed until they try to take it." -Thomas Jefferson

Huntsman 58,NEF 45/70 manlicher stock, H&R 308, 30-06, 12 ga, 20 ga, H&R 223, H&R 204 varmiter,H&R 243, H&R 44mag, SMLE No 1 MKIV,SMLE No4 MK1, Savage 110 7mm, Ruger BH 45LC, Security Six, SR9, S&W 22a, CVA MTN Rifle, Optima

Offline trotterlg

  • GBO Supporter
  • Trade Count: (36)
  • Senior Member
  • *****
  • Posts: 3978
  • Gender: Male
Re: 3/16 dove tail to 3/8 dovetail
« Reply #1 on: September 14, 2010, 06:14:22 AM »
It can be done with a file, but running a cutter through it would be the proper way to do it.  Putting a shim under your rear sight before driving it in should tighten it up for you however.  Larry
Logged
A gun is just like a parachute, if you ever really need one, nothing else will do.

Offline wileynet

  • Trade Count: (30)
  • Contributor
  • ***
  • Posts: 378
  • Gender: Male
Re: 3/16 dove tail to 3/8 dovetail
« Reply #2 on: September 14, 2010, 02:40:15 PM »
i cut some shims from 22 case it did tightened up, but still a little sloppy, do you know of a better 3/16 sight that is not stamped steel
Logged
"The beauty of the second amendment is that it will not be needed until they try to take it." -Thomas Jefferson

Huntsman 58,NEF 45/70 manlicher stock, H&R 308, 30-06, 12 ga, 20 ga, H&R 223, H&R 204 varmiter,H&R 243, H&R 44mag, SMLE No 1 MKIV,SMLE No4 MK1, Savage 110 7mm, Ruger BH 45LC, Security Six, SR9, S&W 22a, CVA MTN Rifle, Optima

Offline trotterlg

  • GBO Supporter
  • Trade Count: (36)
  • Senior Member
  • *****
  • Posts: 3978
  • Gender: Male
Re: 3/16 dove tail to 3/8 dovetail
« Reply #3 on: September 14, 2010, 02:51:50 PM »
I have one of the stamped ones sitting here, it could be tighter than yours, send me your address and I will mail it to you.  Larry
Logged
A gun is just like a parachute, if you ever really need one, nothing else will do.
Pages: [1]   Go Up
« previous next »