Encore Switching Barrels ???

[hogrdr]

Everything I read about switching barrels on Encore frame states I will need to make small adjustments to zero. This is third year I have switched my pro hunter 209X50 to pro hunter 300 win mag. Twice a year after swap load bench, gun and target drive to range set up 100 yards BANG 2" high dead center! I have never made adjustments and gun is dead on. Is this common or am I lucky with frame to barrel on these two barrels? I have two other barrels in 270 win and 22-250 they have there own frame so can't compare with any others. So has anyone else had this happen when switching barrels or is it more common to adjust scope?

Hog

[luckydawg13]

i have 5 barrels same thing dead nuts

[Keith L]

I have Contenders so this is suspect from the start.  I shoot the combo I am going to hunt with prior to hunting.  It gives me confidence in the gun and ammo as well as my own ability.  Since the scope is mounted to the barrel I have never thought I would have to change the scope settings and I never have.  I use the same forend and spacers to float the barrel, and my hinge pins are all within spec as well as frames and barrels.  I have never had a problem, but YMMV.

[Flynmoose]

I have G2s and Encores. I sometimes get "switchitis", changing barrels several
times in one session. I don't remember having to adjust a scope unless I had
a different load to try.
FM

[DEACONLLB]

This year I picked up a G2 walnut stock set and removed the composit set and installed the walnut set took it out and shot it and it was dead on. I switch barrels on my TCR and it is also dead on So I would think that you would not have any problems if you dont mess with the scope but again I do like to check it but I am lucky in that I can shoot here on my farm on my own range.

Deaconllb