Author Topic: Any recommendations for a .405 Win mold? (Read 1024 times)

The Shrink · « **on:** December 24, 2003, 02:05:23 AM »

Veral

I'm thinking of a 300-350 gr, large meplat, alox lubed and cast hard enough to shoot through and through, not counting on expansion, although I may play with a soft nose for thin skinned game. It's to be shot out of a new productin Winchester 95. I'm thinking only one mold for this rifle if possible, and will have to work up loads for it if it's other than 300 grs.

Do you have somethig that would fit or that could be swaged to fit?

Wayne the Shrink

Veral · « **Reply #1 on:** December 30, 2003, 08:42:56 PM »

I think perhaps may catalog isn't clear about the fact that I still cut any diameter or weight bullet anyone asks for so long as it is an LBT profile and within the working limits of my equipment.

I'll make you a 300 gr mold which uses 416 caliber gc's. It will do what you need done.

The Shrink · « **Reply #2 on:** January 02, 2004, 10:53:54 AM »

Veral

Should I order a 2 cavity mold and base (nose?) punch here, or do I need to contact you in another way?

Is this is adeauate, make me a two cavity mold and punch. PM me with payment options and I'll PM you with my mailing address and payment.

I assume I will need a .416 sizer die to seat the gas checks? Or should I wait until I get the rifle and measure the bore and groove, and get a groove size sizer die?

Wayne

Veral · « **Reply #3 on:** January 05, 2004, 05:28:45 PM »

We have no way to take electronic payment at present, so orders must be mailed in with payment. If you have further questions about ordering etc email me at: LBTisAccuracy@Imbris.net and I'll answer you personally.