« previous next »
Pages: [1]   Go Down

Author Topic: pin gage and cylinder  (Read 581 times)

0 Members and 2 Guests are viewing this topic.

Offline luckydawg13

  • GBO Supporter
  • Trade Count: (27)
  • A Real Regular
  • *****
  • Posts: 982
  • Gender: Male
pin gage and cylinder
« on: May 10, 2011, 06:37:11 AM »
i took my cylinder to work to use a pin gage in my cylinder the largest size that i could get to go in was .431 so do i have a .432 sizer made or a .433 this is for a B/H 44MAG
THANK YOU FOR YOUR HELP
Logged
kids that hunt and fish dont mug old Ladies
and drive a F150

Offline Nobade

  • Trade Count: (2)
  • Senior Member
  • *****
  • Posts: 1927
Re: pin gage and cylinder
« Reply #1 on: May 11, 2011, 02:52:21 AM »
.431 - bullets need to be a firm thumb press into the cylinder. Bigger isn't a big deal as long as they chamber, but smaller doesn't work. If the sizer is exactly .431, with springback the bullets should be right on.
Logged
"Give me a lever long enough, and a place to stand, and I'll break the lever."

Offline mdi

  • GBO Supporter
  • Trade Count: (1)
  • Contributor
  • *****
  • Posts: 399
  • Gender: Male
Re: pin gage and cylinder
« Reply #2 on: May 11, 2011, 08:13:32 AM »
Quote from: Nobade on May 11, 2011, 02:52:21 AM
.431 - bullets need to be a firm thumb press into the cylinder. Bigger isn't a big deal as long as they chamber, but smaller doesn't work. If the sizer is exactly .431, with springback the bullets should be right on.
Yep, .431".
Logged
Pages: [1]   Go Up
« previous next »