« previous next »
Pages: [1]   Go Down

Author Topic: Winter Project Blackhawk  (Read 968 times)

0 Members and 1 Guest are viewing this topic.

Offline DennisB

  • Trade Count: (42)
  • Contributor
  • ***
  • Posts: 456
Winter Project Blackhawk
« on: March 28, 2011, 10:29:26 AM »
Finally finished my winter project work on a .45 colt.  It needed some re-blueing and while I had it apart took the finish off the grip frame then gave it a "flat top" haircut.


Logged
Dennis In Ft Worth

Offline Phalanx429

  • Trade Count: (0)
  • Member
  • *
  • Posts: 12
Re: Winter Project Blackhawk
« Reply #1 on: March 31, 2011, 03:47:38 PM »
DennisB...  Your .45 lloks pretty good to me...Old Man Winter was very good to you!  I'm curious about the "haircut" though...perhaps a picture and/or description is in order??
Logged

Offline DennisB

  • Trade Count: (42)
  • Contributor
  • ***
  • Posts: 456
Re: Winter Project Blackhawk
« Reply #2 on: April 01, 2011, 01:45:18 PM »
Phalanx429:  Look closely at the rear sight/top of the mainframe (a closeup pic is below).  This B'hawk wasn't a "flat top" when it left the factory; by "haircut" I meant that I used a couple of files on the top strap to remove the ears around the sight base to make it look like an earlier "flat top" version.  (I'm suprised no one looked at the pre-warning barrel, caliber, etc., and said, "Hey, wait a minute, Jim...") ;D
Logged
Dennis In Ft Worth

Offline Phalanx429

  • Trade Count: (0)
  • Member
  • *
  • Posts: 12
Re: Winter Project Blackhawk
« Reply #3 on: April 05, 2011, 06:03:32 AM »
DennisB... Thank you for the explanation and the side view picture.  All this is very interesting...however, could you give us a "45 degree" (no pun intended) angle and "straight down" picture showing how the top strap came out?  Again thank you for sharing you project with us.
Logged

Offline DennisB

  • Trade Count: (42)
  • Contributor
  • ***
  • Posts: 456
Re: Winter Project Blackhawk
« Reply #4 on: April 08, 2011, 11:45:47 AM »
I'm just starting a similar project on another one--I'll snap a few pics of it as it goes along--
Logged
Dennis In Ft Worth

Offline flatgate

  • Trade Count: (0)
  • Avid Poster
  • **
  • Posts: 158
Re: Winter Project Blackhawk
« Reply #5 on: April 09, 2011, 03:01:51 AM »
Nice! I noticed right away it was a "pre-warning" New Model.  I have a similar example, however the top strap was left original but I switched grip frames from the aluminum to an aftermarket brass version.   A Super hammer seems like the way to go, as well.



Oh, yes, that's a Old Model .45 beside his "Liberty Marked" cousin.........

flatgate
Logged
Pages: [1]   Go Up
« previous next »