Author Topic: Rust Problem  (Read 654 times)

0 Members and 1 Guest are viewing this topic.

Offline Austin from NC

  • Racjarrett88
  • Trade Count: (12)
  • Contributor
  • ***
  • Posts: 410
  • Gender: Male
  • Proudest Uncle Ever
Rust Problem
« on: August 04, 2011, 06:29:18 AM »
What's the best way to kill rust in the bottom of pits.
(choot it, choot it Elizabeth, choot it) Troy Landry

Offline gunnut69

  • Moderators
  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 5005
Re: Rust Problem
« Reply #1 on: August 04, 2011, 11:19:37 AM »
A reverse electrolisis setup will convert red rust, (ferris oxide) to black rust (feric oxide). The latter is soft and easily brushed away..  or just use OxphoBlue a cold bluing solution sold by Brownells. It is in esencially a cold parkerizing colution and the rust at the bottom of a pitt will be stopped.
gunnut69--
The 2nd amendment to the constitution of the United States of America-
"A well regulated militia, being necessary to the security of a free state, the right of the people to keep and bear arms, shall not be infringed."

Offline olydraft

  • Trade Count: (0)
  • Avid Poster
  • **
  • Posts: 165
  • Gender: Male
Re: Rust Problem
« Reply #2 on: August 04, 2011, 11:34:40 AM »
some people don`t like to use it but I found Naval Jelly works good also
If you want it destroyed right, call in a B-52
  "Have B-52 will travel"

Offline gunnut69

  • Moderators
  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 5005
Re: Rust Problem
« Reply #3 on: August 04, 2011, 09:14:11 PM »
naval jelly is made to remove rust but always remember it is also a great blue remover and leaves steel totally unprotected. If any gets on blued steel it will no longer be blued!
gunnut69--
The 2nd amendment to the constitution of the United States of America-
"A well regulated militia, being necessary to the security of a free state, the right of the people to keep and bear arms, shall not be infringed."

Offline Austin from NC

  • Racjarrett88
  • Trade Count: (12)
  • Contributor
  • ***
  • Posts: 410
  • Gender: Male
  • Proudest Uncle Ever
Re: Rust Problem (new question)
« Reply #4 on: August 09, 2011, 04:02:05 AM »
is there any way to nuetralize rust on the inside of a barrel?
(choot it, choot it Elizabeth, choot it) Troy Landry

Offline gunnut69

  • Moderators
  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 5005
Re: Rust Problem
« Reply #5 on: August 09, 2011, 12:01:15 PM »
A penetrating oil called Kroil will get beneath the rust and loosen it so that a brush can remoev it. Of course the pit is still there and that means it is still collecting metal and powder fouling.. If the pits are truly small they can sometimes be smoothed out a bit by lead lapping. Some have had success with fire lapping, which is where bullets charged with abrasive powders are fired down the bore. The problem with that is that it can and often does produce wear in the throat first and that's a bad thing.. Perhaps the best thing to do with a pitted bore is to keep it clean. Layers of bullet metal and powder fouling will hold moisture which is certain to further the rust damage..
gunnut69--
The 2nd amendment to the constitution of the United States of America-
"A well regulated militia, being necessary to the security of a free state, the right of the people to keep and bear arms, shall not be infringed."

Offline Austin from NC

  • Racjarrett88
  • Trade Count: (12)
  • Contributor
  • ***
  • Posts: 410
  • Gender: Male
  • Proudest Uncle Ever
Re: Rust Problem
« Reply #6 on: August 10, 2011, 10:48:55 AM »
thanks gunnut69 my stupid brother in law let his new 760 rust to heck and back. Hope it will still hit the broad side of a barn. The same brother in law that let his cousin use his blr and didn't check the bore which was plugged with mud. When he shot it it blew a hole behind the front sight and a huge swell.
       Austin
(choot it, choot it Elizabeth, choot it) Troy Landry

Offline SHOOTALL

  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 23836
Re: Rust Problem
« Reply #7 on: August 10, 2011, 10:54:48 AM »
Kroil mixed with baking soda applied with a patch wrapped around a brass or nylon bore brush works , a patck made out of silk works also when soaked with kriol.
If ya can see it ya can hit it !