« previous next »
Pages: [1]   Go Down

Author Topic: Barrel cleaning  (Read 619 times)

0 Members and 1 Guest are viewing this topic.

Offline 1Longbow

  • Trade Count: (2)
  • Member
  • *
  • Posts: 98
Barrel cleaning
« on: January 04, 2004, 09:53:11 AM »
Can I ask what you fellow shooters use to remove lead fouling from the barrels and cylinders of your favorite revolvers. I picked up a used GP100 and the previous owner ,shot 38's through it and I can see alot of lead build up . Thanks for your help--1Longbow
Logged

Offline southern utah

  • Trade Count: (0)
  • Contributor
  • ***
  • Posts: 470
    • http://www.jsi-guns-hunting-firearms.com
lead remover
« Reply #1 on: January 04, 2004, 11:05:44 AM »
I use the Birchwood lead remover cloth. I first clean the barrel and cyl with some cleanimg solvent, I cut  small strips of the lead remover cloth ( 3/8" x 3" ) and wrap one around an old brass barrel brush. I run this back and forth in barrel and cyl tell cloth is black. I clean again with cleaning solvent, check for lead and repeat till barrel is clean. Goes pretty quick. Use it on dirty rifles aso.  I was show this by Jim Crews.   www.marksmans.com
Logged

Offline Castaway

  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 1105
  • Gender: Male
Barrel cleaning
« Reply #2 on: January 04, 2004, 11:57:38 AM »
Either a Lewis tool, available from Midway and others or just go to the grocery store, buy a copper scouring pad, cut it up and put a piece over a jag, preferably a size smaller (30 caliber should be just right).
Logged

Offline Savage

  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 4397
Barrel cleaning
« Reply #3 on: January 04, 2004, 02:07:31 PM »
JB's Bore Cleaning Compound"
Savage
Logged
An appeaser is one who feeds the crocodile hoping it will eat him last,

Offline swifty

  • Trade Count: (0)
  • Member
  • *
  • Posts: 73
cleaning-lead removal
« Reply #4 on: January 07, 2004, 08:06:52 AM »
I have heard that the outers foul-out does a great job. Cost is about $75.00
 For a cheaper method ,Check on Veral Smith's section here on shooting cast bullets. Its at the bottom of the page.
Take a bore brush a coupl of sizes smaller. Wrap with a copper scouring pad that has been disassembled . After 6 to 10 passes the lead will be removed-usually. Also, these same folks reccomend that you plug one end of the barrel abd fill barrel with common household ammonia . After a few hours dump the ammonia and clean. Repeat as necessary.
Logged

Offline HappyHunter

  • Trade Count: (9)
  • A Real Regular
  • ****
  • Posts: 664
  • Gender: Male
Barrel cleaning
« Reply #5 on: January 07, 2004, 10:14:27 AM »
I recently purchased an Outers Foul out III (local closeout table for $50.00).  

Its first use was a 41 mag that would not come clean using lead remover cloth patches.   It is now spotless.

Only had it a weed but figure on using it a hole bunch.

HTH

Fred
Logged
Ineedannudernewgun.
NRA Lifetime Member.
Pages: [1]   Go Up
« previous next »