« previous next »
Pages: [1]   Go Down

Author Topic: Gas check size question  (Read 561 times)

0 Members and 1 Guest are viewing this topic.

Offline wileynet

  • Trade Count: (30)
  • Contributor
  • ***
  • Posts: 378
  • Gender: Male
Gas check size question
« on: January 27, 2012, 12:54:00 PM »
finally got some .314 as cast bullets for my 303 British, plan on pan lubing, what size gas checks do i need and where can i get them, my bores both slugged .314 can i push them on then pan lube 
Logged
"The beauty of the second amendment is that it will not be needed until they try to take it." -Thomas Jefferson

Huntsman 58,NEF 45/70 manlicher stock, H&R 308, 30-06, 12 ga, 20 ga, H&R 223, H&R 204 varmiter,H&R 243, H&R 44mag, SMLE No 1 MKIV,SMLE No4 MK1, Savage 110 7mm, Ruger BH 45LC, Security Six, SR9, S&W 22a, CVA MTN Rifle, Optima

Offline Larry Gibson

  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 1069
Re: Gas check size question
« Reply #1 on: January 27, 2012, 04:47:47 PM »
.30 cal.
 
Larry Gibson
Logged

Offline .22-5-40

  • Trade Count: (0)
  • Contributor
  • ***
  • Posts: 253
Re: Gas check size question
« Reply #2 on: February 08, 2012, 07:45:30 PM »
Hello, wileynet.  Larry Gibson is right..I have an 1898 Krag rifle with a .310 groove..those checks are quite a bit oversized at mouth.
   Yes, seat g.c./size, then pan lube..I did this very thing when loading for that old Krag.
Logged

Offline Nobade

  • Trade Count: (2)
  • Senior Member
  • *****
  • Posts: 1927
Re: Gas check size question
« Reply #3 on: February 09, 2012, 02:16:54 AM »
Use a Lee .314 push through die to seat the 30 cal. checks, then pan or dip lube.
Logged
"Give me a lever long enough, and a place to stand, and I'll break the lever."
Pages: [1]   Go Up
« previous next »