« previous next »
Pages: [1]   Go Down

Author Topic: New Project-choke tube question  (Read 411 times)

0 Members and 1 Guest are viewing this topic.

Offline Brewster

  • GBO Supporter
  • Trade Count: (4)
  • Avid Poster
  • *****
  • Posts: 210
  • Gender: Male
New Project-choke tube question
« on: February 17, 2012, 02:37:04 PM »
I'm shortening a Pardner 12 ga single shot barrel to 18+ inches, then plan to ream and tap the bore for rem choke tubes with 4D rental tools. 
Question being... will the choke tubes change "center of pattern" much as compared to "center of pattern" of the cylinder bore now in place?
 
Logged

Offline MSP Ret

  • GBO Supporter
  • Trade Count: (173)
  • Senior Member
  • *****
  • Posts: 8940
  • Gender: Male
Re: New Project-choke tube question
« Reply #1 on: February 18, 2012, 06:18:22 AM »
No it will not, unless it is installed very crooked. If you do a good job with the addittion of the choke tubes (thread the barrel straight and square) it will remain the same....<><....:)
Logged
"Giving up your gun to someone else on demand is called surrender. It means that you have given up your ability to protect yourself to a power that is greater than you." - David Yeagley
Pages: [1]   Go Up
« previous next »